Solar Manufacturing Corporation CE Измеритель уровня
Производитель:
Модель:
CE
Дата:
1941
Категория:
Группа:
Описание:
Capacitor Exameter

Информация

GENERAL The Solar Capacitor Exameter provides service men and laboratories with an Analyzer that combines in one instrument a convenient and simple method of making a complete analysis of condensers under either static or dynamic conditions of operation. The performance characteristics of radio and video receivers have imposed requirements which can be maintained only by the use of high quality component parts. These parts, especially condensers and resistors, must have the proper electrical characteristics to perform their designated functions properly, if satisfactory results are to be obtained from receivers. Condensers have a detrimental effect on reception long before they become entirely defective. The problem of determining the quality or operating efficiency of a condenser requires a complete analysis of its constants. In this instrument condensers may be tested for capacity, leakage, insulation resistance, power factor, opens, shorts, intermittents, and R.F. impedance. Also with the full development of the quick-check features plus the bridge-meter, we find it possible to present an instrument which will give every qualitative and quantitative measurement of capacitors necessary in modern servicing by means of a simple meter reading. It tells the complete performance story of all types of paper, mica, electrolytic, trimmer and air condensers. Checking for quality is done under conditions of either static or dynamic performance; the condenser under test may be operating in a circuit, or it may be disconnected. In addition a vacuum tube voltmeter is provided for measurements of circuit voltage to determine the required voltage rating of the condenser under test. The V.T. voltmeter can be used for aligning R.F. circuits, checking A.V.C. voltages, and checking output levels and signal voltages at various points throughout the receiver. Accurately calibrated markings on the panel are provided for convenient measurements of capacity and resistance. These tests are made on a Wien Bridge with six direct reading ranges, by multiplying the scale reading by the bridge constant. The power factor of electrolytic condensers including A.C. or motor starting types can be read directly from a scale which is calibrated zero to 50% power factor. The capacity range of the instrument is from .00001 mfd. to 2000 mfd., the resistance range from 50 ohms to 10,000 megohms. A meter is used as a null indicator. This change from our previous null indicator for which an electric eye was employed, has been made to provide greater sensitivity and an easier and more positive balance.

показать больше

Руководство пользователя, Схема Cirquit
Hасто́льная кни́га тип:
Руководство пользователя, Схема Cirquit
Страницы:
13
Размер:
5.84 Mbytes (6125830 Bytes)
Язык:
english
Пересмотр:
Hасто́льная кни́га ID:
Дата:
1941 01 01
Качество:
Сканированный документ, читая частично плохо, частично не читается.
Дата загрузки:
2018 07 10
MD5:
3e4aa312824d3c454ba5e5815e6937ff
Загрузки:
404
Обслуживание и Руководство пользователя
Hасто́льная кни́га тип:
Обслуживание и Руководство пользователя
Страницы:
15
Размер:
4.42 Mbytes (4639577 Bytes)
Язык:
english
Пересмотр:
Hасто́льная кни́га ID:
Дата:
1941 01 15
Качество:
Сканированный документ, читая частично плохо, частично не читается.
Дата загрузки:
2015 11 15
MD5:
8ef0049d59f517d588580fd26c7913ec
Загрузки:
496