Tektronix DF 1 Analyzer
Fabricante:
Modelo:
DF 1
Data:
1976
Categoria:
Grupo:
Descrição:
Display Formatter

Informação

The DF1 Display Formatter provides data-domain display modes in addition to the existing time-domain display of the 7D01 Logic Analyzer. It adds state table displays with a comparison mode, and a map display. The DF1 attaches to the left side of the 7D01 forming a three-wide Plug-In assembly. This assembly operates in a 7000-series Oscilloscope mainframe to comprise a complete 16-channel logic timing-state Analyzer system. A microprocessor controlled memory system, contained in the DF1, is capable of recording two 7D01 information records. Portions of both information records may be displayed concurrently in a state table presentation. State tables are displayed in terms of either hexadecimal, octal, or binary formats. This data may be displayed in up to two tables of 17 lines of 16-bit words each. The left-hand table displays data currently stored in the 7D01 memory /7D01 display). The right-hand table displays data that has been transferred from previous 7D01 displays to the DF1 memory (reference display). The DF1 compares the 2 tables and resets the 7D01 when the 7D01 data equals the reference data. The map function plots a dot display of the 16 data channels in X-Y coordinate points. Each dot location represents one possible combination of up to 16 inputs to the 7D01

mostrar mais

Serviço e Manual do Usuário
Tipo de manual:
Serviço e Manual do Usuário
Páginas:
111
Tamanho:
36.09 Mbytes (37841145 Bytes)
Idioma:
english
Revisão:
First Edition
ID de manual:
070-2150-00
Data:
1976 12 01
Qualidade:
Scaned documento, todas legível.
Data de upload:
2017 12 30
MD5:
267c3caeaf4cf378f126de43a6080e96
Downloads:
779

Informação

The Operator's Manual contains information necessary to effectively operate the DF1 Display Formatter unit and is divided into three sections: Section 1 provides packaging for shipment information, specifications, and a list of standard Accessories. Section 2 contains operating information. Information concerning available options is located in Section 3. The Instruction Manual contains nine sections. Operating information is covered in the first two sections; servicing information is covered in the remaining seven sections. Schematic diagrams are located at the rear of the manual and can be unfolded for reference while reading other parts of the manual. The reference designators and symbols used on the schematic diagrams are defined on the first page of the Diagrams and Circuit Board Illustrations section. Abbreviations used in the manuals, except in the parts list and schematic diagrams, comply with the American National Standards Institute Y1.1-1972 publication. The parts list is a computer printout and uses computer-supplied abbreviations.

mostrar mais