Wavetek 175 Gerador
Fabricante:
Modelo:
175
Data:
1978
Categoria:
Grupo:
Descrição:
Arbitrary Waveform Generator

Informação

THE MODEL 175 The model 175, Arbitrary Waveform Generator (Arb), generates any waveform that can be expressed as a function of time. The working Random Access Memory (RAM) has four sets of 256 addresses and each address accepts an 8 bit word. This corresponds to a 1024 (time) by 255 (amplitude) matrix in which to draw waveforms. These storage addresses can be manually loaded by front panel controls or remotely loaded via the GPIB Interface. The stored waveform, or any portion thereof, then can be generated at selectable clock rates and amplitudes. In addition to the four working Random Access Memories (RAMs), four optional Programmable Read Only Memories (PROMs) allow the same capacity for permanent waveform storage. Sine, triangle, square and ramp waveforms are always available. Operation can be continuous or triggered. Triggering can be for a preset number of cycles or the number of cycles triggered can be monitored and displayed. Start and stop addresses are selectable for partial waveform output. At low frequencies, point-to-point smoothing can be selected to minimize digital step size. Output may be held at any level, or amplitude and offset can be slowly ramped to zero when a ramp to zero command is given. Front panel operation is by keyboard and display which gives immediate verification of parameter and value in memory. The model 175 is fully compatible with the requirements of IEEE Standard 488-1975 for integration into a General Purpose Interface Bus (GPIB).

mostrar mais

Manual do Usuário
Tipo de manual:
Manual do Usuário
Páginas:
36
Tamanho:
1.96 Mbytes (2055640 Bytes)
Idioma:
english
Revisão:
ID de manual:
Data:
1980 05 01
Qualidade:
Scaned documento, todas legível.
Data de upload:
2018 08 12
MD5:
1e8e5fb0727f5509c2ba60c26c1c5c20
Downloads:
484
Serviço e Manual do Usuário
Tipo de manual:
Serviço e Manual do Usuário
Páginas:
124
Tamanho:
16.04 Mbytes (16819475 Bytes)
Idioma:
english
Revisão:
ID de manual:
Data:
1983 08 01
Qualidade:
Scaned documento, todas legível.
Data de upload:
2018 08 12
MD5:
b885d51e8263ab3bd94eb0037afade7b
Downloads:
677

Informação

Instruction Manual SECTION 1 GENERAL DESCRIPTION 1.1 THE MODEL 175 ... 1-1 1.2 SPECIFICATIONS ... 1-1 1.2.1 Versatility ... 1-1 1.2.2 Timing Precision ... 1-2 1.2.3 Amplitude Precision ... 1-2 1.2.4 General ... 1-2 SECTION 2 INSTALLATION AND Interface 2.1 MECHANICAL INSTALLATION ... 2-1 2.2 ELECTRICAL INSTALLATION ... 2-1 2.2.1 Power Connection ... 2-1 2.2.2 Signal Connections ... 2-1 2.2.3 General Purpose Instrument Bus (GPIB) Connections ... 2-2 2.2.4 GPIB Address ... 2-2 2.2.5 Initial Checkout and Operation Verification ... 2-3 2.2.6 Permanent Custom Waveforms ... 2-3 SECTION 3 OPERATION 3.1 GENERAL ... 3-1 3.2 KEYBOARD ... 3-6 3.2.1 Notes ... ... 3-6 3.2.2 Key Descriptions ... 3-6 3.3 POWER ... 3-9 3.4 INPUTS AND OUTPUTS ... 3-9 3.5 BASIC COMMAND STRUCTURE ... 3-10 3.6 COUNTER GENERATED WAVEFORMS ... 3-12 3.7 MEMORY DATA (Y) FOR ARBITRARY WAVEFORMS ... 3-12 3.8 SMOOTHING (O) ... 3-12 3.9 SAMPLE TIME (T)AND WAVEFORM SMOOTHING ... 3-13 3.10 CLOCK TIME UNITS (S) ... 3-13 3.11 FULL OR PARTIAL BLOCK (U) ... 3-13 3.12 BLOCK RATE (F) ... 3-14 3.13 AMPLITUDE (A) AND OFFSET (D) ... 3-14 3.14 ERRORS ... 3-15 3.15 PRESET AND MONITOR TRIGGER (M) ... 3-16 3.16 GPIB ... 3-16 3.16.1 Bus Lines Defined ... 3-16 3.16.2 GPIB Commands ... 3-17 3.16.3 GPIB Data Transfers ... 3-18 3.16.4 GPIB Talk Message and Terminator Character (R) ... 3-18 3.16.5 GPIB Service Request Enable (Q) ... 3-19 3.17 INPUT AND OUTPUT IMPEDANCES ... 3-20 3.17.1 Arbitrary Waveform Outputs ... 3-20 3.17.2 TTL Outputs ... 3-20 3.17.3 TTL Inputs ... 3-20 3.17.4 Changing Source Impedance of the Main Output ... 3-20 SECTION 4 CALIBRATION 4.1 INTRODUCTION ... 4-1 4.2 TEST EQUIPMENT ... 4-1 SECTION 5 CIRCUIT DESCRIPTION 5.1 BOARD FUNCTIONS AND CONNECTIONS ... 5-1 5.2 GENERATOR ... 5-1 5.2.1 General ... ... 5-1 5.2.2 Generator Circuits ... 5-3 5.3 DISPLAY AND KEYBOARD ... 5-15 5.3.1 Display ... 5-15 5.3.2 Keyboard ... 5-17 5.4 MICROPROCESSOR ... ... 5-17 5.5 MICROPROCESSOR/GPIB INTERFACE ... 5-23 5.5.1 Data Ready ... 5-23 5.5.2 GPIB Busy ... 5-23 5.5.3 End ... 5-23 5.5.4 Remote ... 5-23 5.5.5 Talk ... 5-23 5.5.6 Listen ... 5-24 5.5.7 Service Request ... 5-24 SECTION 6 TROUBLESHOOTING 6.1 INTRODUCTION ... 6-1 6.2 POWER SUPPLY ... 6-1 6.3 FRONT PANEL DISPLAY ... 6-2 6.4 MICROPROCESSOR ... 6-4 6.5 GPIB INTERFACE ... 6-6 6.5.1 Test 1 — Bus Hung Up ... 6-6 6.5.2 Test 2 — Handshake ... ... 6-9 6.5.3 Test 3 — Listen Mode ... 6-10 6.5.4 Test 4 —Talk Address ... 6-11 6.5.5 Test 5 — Talk Mode ... 6-11 6.6 GENERATOR ... 6-12 SECTION 7 PARTS AND SCHEMATICS 7.1 DRAWINGS ... 7-1 7.2 ORDERING PARTS ... 7-1 7.3 ADDENDA ... 7-1 APPENDIX APPENDIX A American Standard Code for Information Interchange (ASCII) ... A-1 APPENDIX B Programming Examples ... B-1 APPENDIX C Permanent Custom Waveforms ... C-1

mostrar mais

folha de dados
Tipo de manual:
folha de dados
Páginas:
4
Tamanho:
458.97 Kbytes (469986 Bytes)
Idioma:
english
Revisão:
ID de manual:
Data:
Qualidade:
Scaned documento, todas legível.
Data de upload:
2014 11 09
MD5:
df510104d6cc0f997037cc560e1d60c4
Downloads:
697