Wavetek 1001A Gerador
Fabricante:
Modelo:
1001A
Data:
1977
Categoria:
Grupo:
Descrição:
SWEEP/SIGNAL GENERATOR
Informação
The Wavetek 1000 Series Sweep/Signal generators are single band instruments covering the frequency range from 500 KHz to 1.4 GHz. All units utilize the same, Front Panel, Harness and Power supply with the balance of the circuits contained in Plug-In Modules. However, it is not intended that one model be converted to another. The Plug-In concept simplifies maintenance problems and provides marker circuits which can be customized to specific applications. A Rear Panel Con nector permits remote programming of Center Frequency, Sweep Width and Output Level, plus. External Amplitude and Frequency Modulation.

mostrar mais

folha de dados
Tipo de manual:
folha de dados
Páginas:
2
Tamanho:
204.57 Kbytes (209484 Bytes)
Idioma:
english
Revisão:
ID de manual:
Data:
Qualidade:
Scaned documento, todas legível.
Data de upload:
09 Novembro 2014
MD5:
49a327536623397436fefa5f2f38087d
Downloads:
978
Serviço e Manual do Usuário
Tipo de manual:
Serviço e Manual do Usuário
Páginas:
77
Tamanho:
5.97 Mbytes (6263685 Bytes)
Idioma:
english
Revisão:
revised
ID de manual:
Data:
Qualidade:
Scaned documento, todas legível.
Data de upload:
09 Novembro 2014
MD5:
bb6322721f7d6c0b5456cad22d34d599
Downloads:
1506
Informação
This manual provides descriptive material and instructions for the installation, operation, maintenance, and repair of the Wavetek Model 1001A to 1005 Sweep/Signal Generator. SECTION 1 -GENERAL INFORMATION 1.1 INTRODUCTION 1.2 SPECIFICATIONS 1.3 OPTIONS 1.4 Accessories SECTION 2-INSTALLATION 2.1 MECHANICAL INSTALLATION 2.2 ELECTRICAL INSTALLATION SECTION 2—OPERA TING INSTRUCTIONS 31 INTRODUCTION 3.2 DESCRIPTION OF FRONT PANEL 3.3 DESCRIPTION OF REAR PANEL 3.4 TYPICAL OPERATING SET UP 3.5 SPECIAL OPERATING NOTES 3.6 PROGRAMMING SECTION 4 - CIRCUIT DESCRIPTION 4.1 INTRODUCTION 4.2 SIMPLIFIED BLOCK DIAGRAM 4.3 Power supply 4 4 SWEEP RATE (MODULE M1H) 4.5 SWEEP DRIVE (MODULE M2G) 4.6 SWEEP Oscillator FOR MODEL 1001A and 1002 (MODULE M9G and M9H) 4 7 OUTPUT Amplifier FOR MODEL 1001A and 1002 (MODULE M1 OF and M10G) 4.8 SWEEP Oscillator FOR MODEL 1003 1004, and 1005 (MODULE M9R S and'T) 49 MARKER ADDER (MODULE M5G) 4.10 MARKERS (MODULE M6s) SECTION 5 MAINTENANCE 5.1 INTRODUCTION 5.2 SERVICE INFORMATION 5.3 PERFORMANCE CHECKS 5.4 CALIBRATION PROCEDURE 5.5 TROUBLESHOOTING SECTION 6 -SCHEMATICS & PARTS LIST 6.1 INTRODUCTION 6.2 MANUFACTURERS CODE 6.3 SCHEMATIC NOTES 6.4 ABBREVIATION CODE SCHEMATICS AND PARTS LIST

mostrar mais

Comments (0)

No comments yet. Be the first!

Add Comment

* Required information
1000
Captcha Image