Hands on Guide Part 1 — All About the DSO — introduces digital Oscilloscope and how they function, including data sampling, triggering, recording, how sampling rate affects usable bandwidth and long memory improves sampling rate. Also covered are analysis functions such as standard parameters, frequency analysis (FFT) and statistical analysis (histograms). This is the full scope — in the broadest sense of the word! Part 2 — Getting Started — 'physically’ shows you around the scope and teaches, step-by-step, how to capture waveforms and perform simple measurements. You will get to know the instrument and start working with it quickly and effectively. Part 3 — Sharpening Your Measuring Skills — describes systematically and, again, step-by-step how to make important measurements with maximum efficiency, providing detailed descriptions of how to use many of the scope’s advanced functions

Remote Control Manual Chapter 1 — Overview of Remote Control How to Operate the Oscilloscope Remotely...1-1 Chapter 2 — GPIB Communication via the GPIB Bus...2-1 Instrument Polls...2-13 Driving Hardcopy Devices on the GPIB...2-19 Printing by GPIB Controller...2-20 Chapter 3 — RS-232-C Using the RS-232-C Port...3-1 Simulating GPIB Commands with RS-232-C...3-6 Chapter 4 — Waveform Understanding Waveforms...4-1 Using the INSPECT? Query...4-4 WAVEFORM?, Related Commands, and Blocks...4-6 High-Speed Waveform Transfer...4-15 Chapter 5 — Status Registers Using Status Registers...5-1 SYSTEM COMMANDS About These Commands & Queries...1 ... Tabled By Long Form...3 ... Tabled By Subsystem...8 The Commands and Queries...12 Appendix A — GPIB Program Examples Appendix B — Waveform Template Index

Remote Control Manual LeCroy 9300 & LC Oscilloscope Chapter 1 — Overview of Remote Control How to Operate the Oscilloscope Remotely ...1–1 Chapter 2 — GPIB Communication via the GPIB Bus...2–1 Bus Instrument Polls ... 2–13 Driving Hardcopy Devices on the GPIB... GPIB 2–19 Printing by GPIB Controller... Controller 2–20 Chapter 3 — RS-232-C Using the RS-232-C Port...3–1 Port Simulating GPIB Commands with RS-232-C ...3–6 Chapter 4 — Waveform Understanding Waveforms...4–1 Waveforms Using the INSPECT? Query...4–4 Query WAVEFORM?, Related Commands, and Blocks ...4–6 High-Speed Waveform Transfer Transfer... 4–15 Chapter 5 — Status Registers Using Status Registers Registers...5–1 SYSTEM COMMANDS About These Commands & Queries Queries... 1 ... Tabled By Long Form ... 3 ... Tabled By Subsystem ... 8 The Commands and Queries... Queries 12 Appendix A — GPIB Program Examples Appendix B — Waveform Template Index