Tektronix FG 503 Generator
Producent:
Model:
FG 503
Data:
1974
Kategoria:
Grupa:
Opis:
Function Generator

Informacja

The FG 503 Function Generator is designed to operate in a TM 500 series power module. Low distortion sine, square and triangle waveforms from 1 Hz to 3 MHz, are available at the front panel. A +2.5 V square wave trigger also is available at the front panel. Variable dc offset of =5 V is provided. A custom timing switch position is provided. This allows the user to install a timing capacitor for custom tailoring the frequency range of the FG 503, A voltage-controlled frequency (VCF) input controls the output frequency from an external Voltage Source. The output frequency can be swept above or below the selected frequency, to a maximum of 1000:1, depending on the polarity and amplitude of the VCF input and the selected output frequency. The variety of swept and modulated signals available from the FG 503 make it especially useful for such applications as testing servo-system or Amplifier response, distortion and stability. It is also useful for FM generation or as a variable beat-frequency Oscillator. The square wave trigger output can be used as a source for TTL logic, or to synchronize an external device such as an Oscilloscope or counter.

pokaż więcej

Serwis i User Manual
Typ ręczny:
Serwis i User Manual
Strony:
41
Rozmiar:
2.57 Mbytes (2695490 Bytes)
Język:
english
Rewizja:
First Edition
Ręczny ID:
070-1727-00
Data:
1974 04 01
Jakość:
Skanowany dokument, wszystko czytelne.
Data przesłania:
2017 12 28
MD5:
42bd12559f0eea739edf5d4adecb9510
Pobrane:
742

Informacja

SECTION 1 OPERATING INSTRUCTIONS Page Introduction 1-1 Instrument Description 1-1 Initial Operation 1-1 Functions Available At Rear Connector 1-2 Operating Considerations 1-2 Output Connections 1-2 Risetime and Falltime 1-2 Impedance Matching 1-2 Basic Operation 1-4 Free-Running Output 1-4 Voltage-Controlled Frequency (VCF) Output 1-4 Custom Timing Capacitor Selection 1-5 Typical VCF Application 1-6 Electrical Characteristics 1-7 SECTION 2 THEORY OF OPERATION Introduction 2-1 Triangle Generator 2-1 Sine Shaper 2-1 Output Amplifier 2-2 Power Supplies 2-2 SECTION 3 SERVICE INFORMATION Symbols and Reference Designators 3-1 Electrical Replaceable Parts List 3-2 Front Panel Controls and Connectors Calibration Procedure Services Available Maintenance Test Equipment Parts Location Grid Rear Interface Connector Assignments Block Diagram Generator Loop Schematic Output Amplifier Schematic Power Supplies Schematic Mechanical Replaceable Parts List Exploded View Accessories and Repackaging CHANGE INFORMATION

pokaż więcej