Programmed Test Sources Inc. PTS 250 Interfejs
Producent:
Brak zdjęcia!
Może możesz przesłać zdjęcie za
Programmed Test Sources Inc. PTS 250 ?
Jeśli masz jakieś inne podręczniki dla
Programmed Test Sources Inc. PTS 250, możesz przesłać pliki tutaj .
Model:
PTS 250
Data:
1982
Kategoria:
Grupa:
Opis:
GPIB
Informacja
The GPIB Interface implements a standardized form of serial
remote control and provides the necessary hardware to
connect an instrument to the GPIB, also referred to as the
488-bus.
Functional Purpose
The GPIB Interface allows remote programming of the
Synthesizer via the GPIB (General Purpose Interface Bus) in
accordance with the IEEE Std 488-1978.
Three basic functions are accessible through appropriate
commands: frequency, output level and Local/Remote mode. In
the “LISTEN ONLY” mode all valid commands are accepted
without regard to the device address, but in the “ADDR’D”
mode only commands preceded by the selectable “LISTEN” address.
Typ ręczny:
Instrukcja serwisowa
Strony:
33
Rozmiar:
4.73 Mbytes (4964190 Bytes)
Język:
english
Rewizja:
Ręczny ID:
Data:
1982 01 01
Jakość:
Skanowany dokument, wszystko czytelne.
Data przesłania:
2017 01 29
MD5:
88f0937fb0a512a98351d988633d8dce
Pobrane:
495
Informacja
GPIB Interface Description
Introduction
Page
1
Functional Purpose
1
Physical Aspects
2
Operation
4
Setup
5
Programmable Instrument Functions
6
Programming Examples
8
Principles of Operation
11
Condensed GPIB Concept
11
Execution of a Valid Bus Command
13
Listing of Key Signals
16
Specifications
17
Service
18
Maintenance
18
Troubleshooting
18
General
18
Digital Fault Tracking
19
Major Faults
20
1. No Local Control
20
2. No Response
20
3. No Data Transfer
22
4. Single Digit Error
23
5. Same Bit Error
23
Parts List, SEC 1022
24
Parts List, SER 1023
26
Figure 1 (Schematic SEC 1022)
28
Figure 2 (Schematic SER 1023)
29
Figure 3 (PC Assembly, SEC 1022)
30
Figure 4 (PC Assembly, SER 1023)
31