M2 Antenna Systems Inc. RC2800PX-AZ Antena
Producent:
Model:
RC2800PX-AZ
Data:
2003
Kategoria:
Grupa:
Opis:
RS232 Controller

Informacja

Our ALL NEW, GREEN LED, PIC rotator controller is packed with new features including AUTO-CALIBRATE, AUTO SLOW DOWN as limits are approached, ONE STEP PROGRAMMING saving all changes by exiting the program mode. SOFTWARE UPDATES directly from our “m2inc.com” website Also included is increased circuitry and reed switch protection. Of course computer control has also been improved. The new RC-2800PX now accepts fractional inputs like 138.7 degrees and the Auto-calibrate command from a computer or remote site. What we did not change is front and back panel layout so it doesn’t require re-learning the controls and the actual operation is almost identical to the old units. Everything is just a bit smoother and easier. The new PIC microprocessor lends itself to easier custom programming for special rotator control functions. This custom program can be downloaded directly through the RS-232 port on your RC-2800PX from our site on the WEB. Of course this new controller works with any of our older OR-2800DC rotators. It can also be easily modified to work with MOST of our older AC (OR-2800AC) units as well. By ordering an RC-2800PPX controller this design can control a Prop Pitch Rotator with all the same features. If you have a very custom rotator system using a large AC or DC motor of almost any voltage or phase (like 3 phase 240 AC) the RC-2800PX design can control your rotator system. This same controller also controls our line of Elevation rotators (Positioners) like the MT-1000, MT-3000, MT-4000 and the largest, MT- 5000. The Elevation controller can be linked to the AZ controller and both then can be controlled by computer through a single RS-232 line. We also have a Dual controller (RC- 2800PRKX) in one rack mount case to control an AZ-EL system. The new RC-2800PX controller it can handle any gear ratio from 1000 to over 50,000:1 Our OR-2800DC rotator is now supplied with a 60” PIGTAIL and a WATER TIGHT HOUSING for a terminal strip. This creates an easy access, trouble free control cable connection. Your control cable can have as few as 2 motor wires (see the “size VS distance” information later in manual) and a small single shielded lead for the position feedback.

pokaż więcej

Instrukcja obsługi, Cirquit diagramu
Typ ręczny:
Instrukcja obsługi, Cirquit diagramu
Strony:
19
Rozmiar:
743.58 Kbytes (761424 Bytes)
Język:
english
Rewizja:
Ręczny ID:
Data:
Jakość:
Skanowany dokument, wszystko czytelne.
Data przesłania:
2015 09 19
MD5:
407592f822ac57fdedecfe9a71b137bb
Pobrane:
788

Informacja

COVER PAGE TABLE OF CONTENTS 2 FEATURES 3 GETTING STARTED 4 FRONT PANEL CONTROLS 5 RUN MODES 6 PROGRAMMING MODES & CALIBRATION 7,8 PROGRAMMING PRESETS 9 REAR PANEL AND INSTALLATION HINTS 10 OPERATION BY COMPUTER 11 AZ AND EL OPERATION BY COMPUTER 12 WRITING CONTROL SOFTWARE 13,14 TROUBLE SHOOTING 15,16 SIMPLIFIED THEORY OF OPERATION 17 WIRING AND PARTIAL PCB SCHEMATIC 18 WARRANTY 19

pokaż więcej