Wavetek 157 Generator
Producent:
Zdjęcie 1 z 1
Jeśli masz inne zdjęcia lub instrukcje obsługi dla
Wavetek 157, możesz przesłać pliki tutaj .
Model:
157
Data:
0
Kategoria:
Grupa:
Opis:
PROGRAMMABLE WAVEFORM SYNTHESIZER
Informacja
The model 157 is a precision source of selectable sine,
square, or triangle waveforms that are generated from 100
μΗz (2% hours per cycle) to 1 MHz in 10 ranges. Output
amplitudes are selectable from 1 millivolt to 10 volts,
peak-to-peak, into a 50-ohm load. This instrument
incorporates a voltage-controlled Generator that may be
swept over a 1000:1 frequency ratio with a 0-volt to 5-volt
analog input for frequency modulation of the selected output
frequency.
Four modes of operation can be programmed with the
front-panel controls. Three modes of operation are
programmable from a remote source by static logic levels or
contact closures. Frequency, amplitude, and function also
are programmable from either the front-panel controls or a
remote source.
The instrument is packaged for mounting in a standard
19-inch rack or for operating on a test bench.
Typ ręczny:
Serwis i User Manual
Strony:
80
Rozmiar:
8.13 Mbytes (8525652 Bytes)
Język:
english
Rewizja:
Ręczny ID:
Data:
Jakość:
Dokument elektroniczny, bez skanowania, bardzo dobrze czytelne.
Data przesłania:
2014 11 17
MD5:
d81cceae6291bbd0c1998497491f4019
Pobrane:
1088
Informacja
This manual provides instructions for operating, testing,
and maintaining the Wavetek Programmable Waveform
Synthesizer. Sections 1 through 5 include the necessary
information for the basic model 157. Section 6 consists of
Difference Data that describe specific differences, if any,
from the basic model.
Section 1 GENERAL DESCRIPTION
Scope of
Manual ... 1-1
Scope of Equipment
... 1-1
Modes of Operation
... 1-1
Remote Control
Operation ... 1-2
Functional
Descriptions ... 1-2
Specifications ... 1-3
Section 2 OPERATING INSTRUCTIONS
Installation ... 2-1
Inspection
... 2-1
Manual Operation
... 2-4
Programming
... 2-5
Section 3 CIRCUIT DESCRIPTION
Introduction
... 3-1
Program Selection
... 3-1
Basic Generator
... 3-3
Low-Frequency
Generator ... 3-6
Sine Conversion
... 3-7
Tone Burst Generation
... 3-7
Power
Supply ... 3-9
Section 4 MAINTENANCE
Introduction
... 4-1
Recommended Test
Equipment ... 4-1
Checkout and Calibration
... 4-1
Troubleshooting ... 4-4
Replacement of Circuit Boards
... 4-5
Replacement of Rotary Switches, Dials, or Decimal Lamps
... 4-6
Section 5 DATA PACKAGE
Introduction
... 5-1
Arrangement
... 5-1
List of
Manufacturers ... 5-1