Hewlett Packard 608B Generator
Fabrikant:
Geen foto beschikbaar!
Misschien kan je een foto uploaden voor de
Hewlett Packard 608B ?
Als je nog andere handleidingen hebt voor de
Hewlett Packard 608B kun je hier de bestanden uploaden .
Model:
608B
Datum:
Categorie:
Groep:
Omschrijving:
VHF Signal Generator
Informatie
The Hewlett-Packard Model 608C VHF Signal Generator is a
general purpose test instrument which furnishes accurately
adjustable r-f signals from 0.1 microvolt to 1 volt over the
frequency range from 10 to 480 megacycles. The output signal
may be amplitude modulated by internally generated sine
waves or by externally applied sine waves or pulses. The
output signal level is adjustable by an attenuator
calibrated in both volts and dbm and can be read directly to
an accuracy of ±1 db over the full frequency and attenuation
range without the use of external pads, monitoring devices,
or charts. The 608C features a very wide frequency range,
high output, and straightforward operation through the use
of reliable, direct-reading controls and meters.
The Model 608C Signal Generator is designed for general
applications in the 10- to 480-megacycle frequency range,
such as testing, calibrating, and trouble shooting VHF radio
equipment and circuits. In conjunction with other test
equipment, the 608C is useful for measuring standing wave
ratios, antenna and transmission line characteristics,
receiver sensitivity, etc. To obtain best accuracy in these
applications, care has been taken to hold spurious
modulation from the Generator to a very low value.
Handleidingen type:
Servicehandboek
Pagina’s:
10
Grootte:
1.09 Mbytes (1147842 Bytes)
Taal:
english
Herziening:
Handleidingen-ID:
Datum:
Kwaliteit:
Gescande document, lezen deels slecht, deels niet leesbaar.
Upload datum:
2017 12 30
MD5:
ef8d9c8c6179ca99bc7510c1835fba02
Downloads:
1977
Informatie
Service Notes
This Service Note contains information necessary for
replacing and recalibrating the output attenuator in the
608A/B/C/D/E/F Signal Generators. The procedure is described
for each model, using the appropriate replacement attenuator.
This Service Note outlines the procedure for modifying the
Model 608C.D VHF Signal Generators for regulated DC filament
operation of the RF circuits.
The original multivibrator filament Power supply in Some
cases caused ripple on the output RF signal from the
generator. The DC filament supply prevents this from happening.