Hewlett Packard 608A Generator
Fabrikant:
Afbeelding 1 van 1
Als je nog andere foto's of handleidingen hebt voor de
Hewlett Packard 608A kun je de bestanden hier uploaden .
Model:
608A
Datum:
1953
Categorie:
Groep:
Omschrijving:
VHF Signal Generator
Informatie
The Model 608A Signal Generator is a general purpose
laboratory Generator covering the 10 to 500 megacycle band.
Both the frequency and output are calibrated. Internal
modulation at either of two fixed frequencies is provided.
The instrument may also be modulated from external sources
of sine waves or pulses.
The Model 608A may be used for measuring gains selectivity
or image rejection of receivers, IF and broad band
amplifiers. The high output voltage (1 volt into a 50 ohms
load) of the Generator is suitable for driving bridges,
slotted lines, transmission lines, antennas, and Filter
networks.
Handleidingen type:
Service-en gebruikershandleiding
Pagina’s:
37
Grootte:
3.21 Mbytes (3362512 Bytes)
Taal:
english
Herziening:
Handleidingen-ID:
Datum:
1953 01 01
Kwaliteit:
Gescand document alle leesbaar.
Upload datum:
2017 12 30
MD5:
e770cac87ae69e3d71f4f3a3b5a52da1
Downloads:
356
Handleidingen type:
Servicehandboek
Pagina’s:
10
Grootte:
1.09 Mbytes (1147842 Bytes)
Taal:
english
Herziening:
Handleidingen-ID:
Datum:
Kwaliteit:
Gescande document, lezen deels slecht, deels niet leesbaar.
Upload datum:
2017 12 30
MD5:
ef8d9c8c6179ca99bc7510c1835fba02
Downloads:
1977
Informatie
Service Notes
This Service Note contains information necessary for
replacing and recalibrating the output attenuator in the
608A/B/C/D/E/F Signal Generators. The procedure is described
for each model, using the appropriate replacement attenuator.
This Service Note outlines the procedure for modifying the
Model 608C.D VHF Signal Generators for regulated DC filament
operation of the RF circuits.
The original multivibrator filament Power supply in Some
cases caused ripple on the output RF signal from the
generator. The DC filament supply prevents this from happening.