Yaesu FT-840 Transceiver
Fabrikant:
Geen foto beschikbaar!
Misschien kan je een foto uploaden voor de
Yaesu FT-840 ?
Als je nog andere handleidingen hebt voor de
Yaesu FT-840 kun je hier de bestanden uploaden .
Model:
FT-840
Datum:
0
Categorie:
Groep:
Omschrijving:
Handleidingen type:
Servicehandboek
Pagina’s:
166
Grootte:
8.20 Mbytes (8602472 Bytes)
Taal:
english
Herziening:
Handleidingen-ID:
Datum:
Kwaliteit:
Gescande document, lezen deels slecht, deels niet leesbaar.
Upload datum:
2014 07 27
MD5:
27f89f792fd6d6e5a5f572581da1f2b0
Downloads:
2265
Informatie
Introduction & Chip Component Information ... 1-1
Circuit Board Access, Battery & Lamp Replacement ... 2-1
Alignment ... 3-1
Block Diagram & Interconnection Diagram ... 4-1
Board Unit (Schematics, Layouts & Parts)
MAIN Unit ... 5A-1
LOCAL Unit ... SB-1
DDS-1 Unit ... 5C-1
DDS-2 Unit ... 5D-1
OSC Unit ... 5E1
REG Unit ... 5F-1
DISPLAY Unit ... 5G-1
LPF Unit ... 5H-1
PA Unit ... 51-1
VR-A/-B/-C/-D Unit ... 5J-1
SW-A/-B/-C/-D Unit ... 5K-1
MIC Unit ... 5L-1
Phone Unit ... 5M-1
Exploded View & Miscellaneous Parts ... 6-1
Accessory & Optional Board Units (Schematics, Layouts & Parts)
TCXO-4 Master Reference Oscillator
(option) ... 7A-1
FM Unit-747 (option) ... 7B-1
YF-112A AM Crystal Filter
(option) ... 7C-1
YF-112C CW Crystal Filter
(option) ... 7D-1
FC-10 Automatic Antenna Tuner
(option) ... 7E-1
MH-1B8 Hand-Held Microphone (accessory)
... 7F-1
MD-1C8 Microphone (option) ... 7G-1
YH-77ST Lightweight Headphones
(option) ... * ... 7H-1
This manual provides the technical information necessary for
servicing the FT-840 hf Transceiver. It does not include
information on specifications, installation and operation,
which are described in the FT-840 Operating Manual, provided
with the Transceiver, or on FT-840 accessories, which are
described in the manuals provided with each.
Servicing this equipment requires expertise in handling
surface-mount chip components. Attempts by non-qualified
persons to service this equipment may result in permanent
damage not covered by warranty.
For the major circuit boards, each side of the board is
identified by the type of the majority of components
installed on that side. In most cases one side has only chip
components, and
the other has either a mixture of both chip and leaded
component (trimmers, coils, electrolytic capacitors,
packaged ICs, etc.), or leaded components only.