Your new STA-95 is a highly versatile AM/FM Stereo Receiver which delivers enough power to drive almost any Speaker ystem. The "honest" 45 watts per channel over the entire audio bandwidth will drive both "main" and "remote" Speaker And it has the performance and convenience features that distinguish a truly great Receiver • A special button switches the FM de-emphasis circuits to let you enjoy Dolby* I (VI broadcasts by using a Dolby NR decoder. • With the FM Tuner the specifications tell the story. There's an FET front-end for excellent sensitivity and reduced noise. When you lime, muting eliminates interstation hiss. • AM & FM IF sections use linear IC's which assure minimum noise and low distortion, combined with high gain. • FM Multiplex circuit is a Phase Lock Loop 1C (PLL-IC) which provides rock-stable stereo separation even with temperature changes. • A linear 1C is used in the Phono Preamp to obtain wide dynamic range and low distortion. • Tape Dubbing switch allows two-way tape dubbing without troublesome rear panel connection changes. • Full Tape Monitor control. • The wideband Tuner provides maximum AM fidelity. • Front panel jacks let you listen to any source or make tape recordings without troublesome rear panel connections. - Built-in automatic thermal and overload protection. At Radio hack we also believe a Receiver hould look as good as it sounds. The STA-95 comes with a beautiful genuine walnut veneer case—and it doesn't cost you a penny extra.