WRL Electronics 666 Ander
Fabrikant:
Geen foto beschikbaar!
Misschien kan je een foto uploaden voor de
WRL Electronics 666 ?
Als je nog andere handleidingen hebt voor de
WRL Electronics 666 kun je hier de bestanden uploaden .
Model:
666
Datum:
0
Categorie:
Groep:
Omschrijving:
VFO Variable Frequency Oscillator
Informatie
1-1. GENERAL.
1-2, The VFO, model 666, is made by WRL Electronics, Inc. of
Council Bluffs, Iowa. The VFO, model 666, is completely
self-contained, including Power Supply and is calibrated for
the six meter amateur band.
RF output from the VFO is on the fundamental frequencies
between 8330 and 9000 KC requiring suitable multiplier
stages in the Transmitter to obtain six meter output. Full
170° bandspread of the tuning dial is incorporated for
operating convenience.
I-3. DESCRIPTION.
1-⅛. The VFO, model 666, is housed in a distinctive cabinet
of modern design. Dimensions are 6-5/8" high, 7⅛11 long and
7" vide. Weight is approximately 7 pounds. Among the various
features is the CALIBRATE switch on the front panel of the
VFO. The switch allows the operator to energize the VFO
independently of the Transmitter in order to "zero- beat" a
received signal. A new exclusive feature called VFO
BANDSPREAD permits very precise tuning of the VFO and
eliminates "overshoot" when "zero-beating" a specific
signal. RF output is obtained through a cable connected to
the rear chassis connector labeled OUTPUT. Length of this
cable should not exceed four feet. The VFO may be removed
from the cabinet for service and inspection by removing the
two top panel screws and the two rear chassis screws. Power
requirements are 115V AC,
50/60 cycles, 10 watts.
Handleidingen type:
Service-en gebruikershandleiding
Pagina’s:
11
Grootte:
1,001.43 Kbytes (1025465 Bytes)
Taal:
english
Herziening:
Handleidingen-ID:
Datum:
Kwaliteit:
Gescand document alle leesbaar.
Upload datum:
2014 07 06
MD5:
a270c98ae86fa2b06f492c7d23c636a0
Downloads:
617
Informatie
TABLE OF CONTENTS
Section 1. General Description— ... 1
Section II. Operating Procedure ... 2
Section III. Trouble Shooting and Alignment
Procedure ... 14-
Section IV. Parts List ... — ... 7