Hewlett Packard 608B Générateur
No picture available!
Maybe you can upload a pic for the
Hewlett Packard 608B ?
If you have any other manuals for the
Hewlett Packard 608B you can upload the files here .
VHF Signal Generator
The Hewlett-Packard Model 608C
VHF Signal Generator
general purpose test instrument which furnishes accurately
adjustable r-f signals from 0.1 microvolt to 1 volt over the
frequency range from 10 to 480 megacycles. The output signal
may be amplitude modulated by internally generated sine
waves or by externally applied sine waves or pulses. The
output signal level is adjustable by an attenuator
calibrated in both volts and dbm and can be read directly to
an accuracy of ±1 db over the full frequency and attenuation
range without the use of external pads, monitoring devices,
or charts. The 608C
features a very wide frequency range,
high output, and straightforward operation through the use
of reliable, direct-reading controls and meters.
The Model 608C
is designed for general
applications in the 10- to 480-megacycle frequency range,
such as testing, calibrating, and trouble shooting VHF radio
equipment and circuits. In conjunction with other test
equipment, the 608C
is useful for measuring standing wave
ratios, antenna and transmission line characteristics,
receiver sensitivity, etc. To obtain best accuracy in these
applications, care has been taken to hold spurious
modulation from the Generator
to a very low value.
manuel de réparation
1.09 Mbytes (1147842 Bytes)
Document scanné, la lecture en partie mal, en partie illisible.
30 December 2017
This Service Note contains information necessary for
replacing and recalibrating the output attenuator in the
608A/B/C/D/E/F Signal Generators. The procedure is described
for each model, using the appropriate replacement attenuator.
This Service Note outlines the procedure for modifying the
.D VHF Signal Generators for regulated DC filament
operation of the RF circuits.
The original multivibrator filament Power supply
cases caused ripple on the output RF signal from the
generator. The DC filament supply prevents this from happening.