Document scanné, tous les lisible.
OPERATING AND PROGRAMMING MANUAL
This manual applies to Models 1630A
.D (Option 007) and all
instruments. It also applies to 1630A
prefixed 2424A and below, and 1630D
instruments serial prefixed
2428A and below.
This manual describes how to operate the Hewlett-Packard
Analyzers. The three analyzers operate the same, but each
have different configuration capabilities. The
is the latest configuration with added performance
measurement capabilities that are not possible with
logic analyzers. The differences are
described, wherever applicable, throughout this
manual . This first chapter describes the physical and
electrical characteristics of the Analyzer
. At the end of
this chapter are two tables: one lists the Analyzer
specifications guaranteed by HP, and the other lists the
This manual contains instructions and information to help
you install and operate the logic Analyzer
. It shows
how to assign labels in the format specification to identify
signals from the input probes, and how to assign
symbols to represent values found on those labeled inputs.
Chapter 2 describes how to set up the logic Analyzer
use. Directions are given for connecting the Probe
cables to a system under test and initiating the Analyzer
self test .
Chapter 3 contains a menu map and afront panel keyboard
description. The menu map helps to put the overall
operation of the Analyzer
into perspective . Page numbers
are given byeach menu to reference the description
of the menu in the manual .
Chapter 4 of this manual is State Measurements . The basic
state measurements, from taking a trace in a freerun
mode to selective tracing, is explained in a step-by-step
Chapter 5 contains the Software
measurements . Although these measurements are
state measurements, an entire chapter is devoted to them
because of the complexity of overview analysis .
Chapter 6 is a description of the timing measurements .
Simple timing measurements are described in a stepby-
Chapter 7 describes interactive state/timing measurements .
Chapter 8 is a description of the system peripheral menus of
.D and the 1630G
Chapter 9 contains the instructions used for programming the
1630 logic analyzers via HP-113 or HP-IL.
Appendix A contains all the possible display messages that
may appear on the Analyzer
screen . An HP-113
overview is given in Appendix B for use as a reference for
programming over the HP-113 . Appendices C, D, and
E explain using a printer, tape memory, or disc memory
with the logic Analyzer