Hewlett Packard - 606A - Générateur
Fabricant:
Pas d’image disponible!
Peut-être que vous le pouvez
Télécharger une photo
pour l'
Hewlett Packard606A ?
Si vous avez d'autres manuels pour le
Hewlett Packard 606A
vous pouvez
télécharger les fichiers ici.
.
Matériels:
606A
Date:
1971
Catégorie:
Groupe:
Sous-groupe:
Information
The Hewlett-Packard Model 606A is a general-purpose signal Generator with a frequency range of 50 kHz to 65 MHz. The
instrument has a direct reading frequency dial calibrated to
an accuracy of 1%. Output is held constant within ± 1 dB and
is continuously adjustable from.01 microvolt to 3 volts into
a 50 ohm resistive load. An internal crystal Calibrator provides check points at 100 kHz and 1 MHz intervals with an
error of less than 0.01%. A front-panel meter accurately
indicates the percent amplitude modulation for frequencies
within the modulation bandwidth of the signal Generator The Model 606A has a highly refined amplitude modulation
system which allows modulation up to 90% with low distortion
and incidental FM. This feature makes possible precision
distortion checks of receivers from antenna to output. The
instrument can be internally modulated at 400- or 1000 Hz.
It can be externally modulated from dc to 20kHz or more,
depending on RF frequency in use. Complex waveforms, square
waves, and dc voltages may be used to modulate the Model 606A for testing and evaluating Filter networks Amplifier and receivers.
DIFFERENCES BETWEEN INSTRUMENTS.
The Model 606A carries a five-digit serial number with a
three-digit prefix (000-00000). The prefix changes only when
a change is made in the instrument. The prefix, then, is an
identifier, and it appears on the title page of this manual
to indicate to which instrument this manual directly
applies. A supplement may be included with this manual to
indicate the necessary changes to be made in the manual to
make it apply directly to instruments which carry a
different serial number prefix.
1 Manuel
Manuel d'entretien et d'utilisation
Type manuel:
Manuel d'entretien et d'utilisation
Pages:
70
Taille:
3,6 Mio
Langue:
anglais
Révision:
Manuel-ID:
00606-90013
Date:
mai 1971
Qualité:
Document scanné, tout est lisible.
Date de téléchargement:
30 décembre 2017
MD5:
df7ce818-f244-d664-c91c-0f49cb0b23fb
Information
This manual applies directly to HP Model 606A High Frequency
Signal Generator having serial prefix number 0960A.
I GENERAL INFORMATION ...1-1
1-1. General Description ...1-1
1-4. Differences between Instruments . 1-1
1-6. Unpacking and Inspection ... 1-1
1-11. Installation Instructions...1-2
1-14. Power Cable...1-2
1*16 Accessories Available...1-2
II OPERATING INSTRUCTIONS...2-1
2-1. Output Termination...2-1
2-5. Setting the Cursor...2-1
2-7. Output Attenuator ...2-1
2-9. Use of the 3-Volt Range...2-1
2-11. External Modulation...2-1
2-13. External Synchronization Signal . 2-1
2-15. B+ Fuse...2-1
2-17. Modulation Data...2-1
III THEORY OF OPERATION...3-1
3-1. Overall Operation...3-1
3-3. Circuit Description...3-1
IV MAINTENANCE...4-1
4-1. Introduction...4-1
4-3. Cabinet Removal...4-1
4-4. RF Shield Removal...4-2
4-5. Test Equipment Required ... 4-2
4-7. Tube Replacement...4-2
A ppendix - Manual
Section Page
IV MAINTENANCE (Cont’d)
4-11. Front Panel Operation Check ... 4-3
4-13. Preliminary Check...4-3
4-15. Modulation Meter Calibration . . 4-3
4-16. Frequency Calibration...4-3
4-18. Output Level Frequency Response 4-3
4-19. Troubleshooting ...4-4
4-27. Turn-On Procedure After Repair . 4-9
4-29. Mcchanical Adjustment of Meter Zero 4-9
4-31. General Test and Alignment ... 4-9
4-36. Power Supplies ...4-10
4-42. Audio Oscillator 4-10
4-43. Crystal Calibrator 4-10
4-44. Tune Oscillator and Amplifier 4-10
4-45. Set Maximum Oscillator Current . 4-11
4-46. Carrier Zero Set...4-T1
4-47. Maximum Carrier Set and
Modulation Zero Set...4-12
4-48. Set Percent Modulation Meter . . . 4-12
4-49. RF Output Meter Calibration . . . 4-12
4-50. Attenuator Repair...4-12
4-52. Adjust Feedback Relay ...4-13
4-54. Drive Cable Assembly Replacement 4-13
4-56. Performance Check...4-14
4-58. Frequency Calibration...4-14
4-59. Output... . 4-14
4-60. Modulation...4-14
4-61. Frequency Drift...4*14
V REPLACEABLE PARTS...5-1
5-1. Introduction...5-1
5-5. Ordering Information...5-1
Téléchargements:
543
Télécharger
hewlett-packard--606a--service-user--ID10069.pdf