Keithley 7063 Interfaz
Fabricante:
Modelo:
7063
Fecha:
1984
Categoría:
Grupo:
Descripción:
RF Scanner Card

Información

The Model 7063 is an RF scanner card that switches RF signals (up to 500MHz) from one channel to another. All channels switched are terminated into 50tl when not selected. When a channel is closed, the RF signal is routed from the input to the output. The Model 7063 works in conjunction with a scanner mainframe such as the Keithley model 705 or model 706. The Model 7063 incorporates two 1X5, switches on each card. Each switch has a separate common (ground). This allows two signals to be switched at the same time. One 1X5 switch could be cascaded with the other 1X5 switch (on the same card) for a 1 X 10 switch configuration. Thus, the Model 7063 is configurable for several different switch configurations. Specified relay life is greater than 100,000 closures. Cables are routed from the rear of the card. The front plugs into the mainframe (e.g. model 705 or model 706). The mainframe must be in the matrix mode or 2-pole mode to operate the channels on the Model 7063 card. BNC connectors allow easy connections to input/output signal paths.

ver más

Servicio y Manual del usuario
Type manuel:
Servicio y Manual del usuario
Páginas:
30
Tamaño:
742.69 Kbytes (760517 Bytes)
Idioma:
english
Revisión:
A
Manuel-ID:
7063-901-01
Fecha:
Formato:
Documento Scaned, todo legible.
Fecha de subida:
02 marzo 2014
MD5:
674717ccb8a646a79f7258f6045355fc
Descargas:
712

Información

SECTION 1 GENERAL INFORMATION 1.1 Introduction ... 1 1.2 Warranty Information ... 1 1.3 Manual Addenda ... 1 1.4 Safety Symbols and Terms ... 2 1.5 Unpacking and Inspection ... 2 1.6 Specifications ... 2 SECTION 2- OPERATION 2.1 Introduction ... 3 2.2 Safety Precautions ... 3 2.3 Wiring ... 3 2.3.1 t of 11 Switch ... 4 2.3.2 I of 11 Matrix ... 6 2.4 Installation ... 8 2.4.1 Removal ... 8 2.5 Operation ... 8 2.6 Switch TerminoloRy ... 10 SECTION 3—SERVICE INFORMATION 3.1 Introduction ... 13 3.2 Required Test Equipment ... 13 3.3 Performance Verification Procedure ... 14 3.3.1 Insertion Loss ... 14 3.3.2 Channel Isolation ... 14 SECTION 4—REPLACEABLE PARTS 4.1 Introduction ... 17 4.2 Replaceable Parts ... 17 4.3 Ordering Information ... 17 4.4 factory Service ... 17 4.5 Component Layout and Schematic Diagram ... 17

ver más

Comentarios

Sin comentarios aún. ¡Sé el primero!

Agregar comentario

* Información requerida
1000
Captcha Imagen