Tektronix FG 504 Generador
Fabricante:
Imagen 1 de 1
Si tienes otras fotos o manuales para el
Tektronix FG 504 puedes subir los archivos aquí .
Modelo:
FG 504
Fecha:
1979
Categoría:
Grupo:
Descripción:
40MHz Function Generator
Información
Introduction
The FG 504 Function Generator provides low distortion sine,
square, triangle, ramp, and pulse waveforms over the
frequencies from 0.001 Hz to 40 MHz in ten decades. A
user-definable custom frequency range is also available. The
output amplitude is 10 mV to 30 V peak-to-peak into an open
circuit and 5 mV to 15 V peak-to-peak into a 50 Q load. The
output impedance is 50 Q. The FG 504 may be swept between
the START and STOP FREQ dial settings with a linear or
logarithmic sweep. The output may be phase locked, gated, or
triggered for single cycle output. The output waveform may
be shifted ±80° from the triggering waveform. The symmetry
of the output waveform may also be varied. For the slower
frequencies, the output may be held at any level by pushing
the front panel button labeled HOLD.
A voltage-controlled frequency (VCF) input controls the
output frequency from an external Voltage Source. The output
frequency can be swept above or below the selected
frequency, to a maximum of 1000:1, depending on the polarity
and amplitude of the VCF input and the selected output
frequency. Provision is also made for amplitude modulating
the sinewave output from an external source.
The variety of swept and modulated signals available from
the FG 504 make it especially useful for such applications
as testing Amplifier or servo-system response, distortion,
and stability. It is useful for fm generation, as a beat
frequency Oscillator, as a gated triggered or phase-locked
logic Interface, or as a source for various ramp or pulse
waveforms. It is also useful as a source for amplitude
modulated signals for various purposes.
Type manuel:
Servicio y Manual del usuario
Páginas:
178
Tamaño:
15.83 Mbytes (16599429 Bytes)
Idioma:
english
Revisión:
revised
Manuel-ID:
070-2655-00
Fecha:
1982 05 01
Formato:
Documento Scaned, todo legible.
Fecha de subida:
2017 04 23
MD5:
d52495b12e1d4a86c0fa80492bf05d3b
Descargas:
851
Información
LIST OF ILLUSTRATIONS ... ii
LIST OF TABLES ... iii
Section 1 SPECIFICATION ... 1-1
Section 2 OPERATING INSTRUCTIONS ... 2-1
English Version French Version German Version Japanese Version
WARNING
THE FOLLOWING SERVICE INSTRUCTIONS ARE FOR USE BY QUALIFIED
PERSONNEL ONLY. TO AVOID PERSONAL INJURY, DO NOT PERFORM ANY
SERVICING OTHER THAN THAT CONTAINED IN OPERATING
INSTRUCTIONS UNLESS YOU ARE QUALIFIED TO DO SO.
Page
Section 3 THEORY OF OPERATION ... 3-1
Section 4 CALIBRATION PROCEDURE ... 4-1
Performance Check ... 4-3
Adjustment Procedure ... 4-8
Section 5 MAINTENANCE ... 5-1
Section 6 OPTIONS ... 6-1
Section 7 REPLACEABLE ELECTRICAL PARTS 7-1
Section 8 DIAGRAMS AND ILLUSTRATIONS . . 8-1
Section 9 REPLACEABLE MECHANICAL PARTS 9-1