Rohde & Schwarz AMIQ 1110.2003.04 Generator
No picture available!
Maybe you can upload a photo for the
Rohde & Schwarz AMIQ 1110.2003.04 ?
If you have any other manuals for the
Rohde & Schwarz AMIQ 1110.2003.04 you can upload the files here .
I/Q Modulation Generator
AMIQ is a modulation source for complex baseband signals of
telecommunication networks. Two synchronous outputs, which
are matched to each
other, and a large memory together with wide analog
bandwidth make AMIQ suitable
for universal use.
AMIQ has been designed to generate I and Q signals in the
baseband for present and
future types of modulation. "I" stands for the in-phase
component, "Q" for the
The data to be output by AMIQ are normally calculated by an
external workstation (eg
PC). To control this calculation, Rohde & Schwarz offers two
and AMIQ Control, a Software
for R&S vector signal Generator
SMIQ (see Section
"Software for AMIQ Control on page 1.8"). The desired
information data stream (eg a
piece of speech) is generated and a modulation mode
selected. Then various
interference and distortions (so-called impairments) are
superimposed to this (ideal)
baseband signal. Thus a long sequence of sample values is
obtained, which are
loaded into AMIQ (via floppy, IEC/IEEE bus or RS-232
interface). The sequence in
the AMIQ memory is then output as analog I and Q signals
with the aid of fast and
accurate D/A converters. The outputs are (normally)
connected to the modulation
inputs of an I/Q modulator (eg SMIQ), which modulates the
baseband signal onto the
2.03 Mbytes (2133294 Bytes)
Electronic document, no scan, very well readable.
11 December 2016
The operating manual consisting of a data sheet and 10
chapters contains comprehensive informa-
tion on characteristics, putting into operation, operation
and remote control of AMIQ:
The data sheet
informs about guaranteed specifications and characteristics.
describes the operating principle of AMIQ, control elements
and connectors on
the front and rear panel as well as all procedures required
for putting the instru-
ment into operation and integration into a test system.
details instrument control via the remote interfaces with
the aid of program ex-
presents control and display elements.
describes key operating modes and special characteristics
of AMIQ with refer-
ence to possible applications.
describes programming of AMIQ, command processing, status
and characteristics of hardware interfaces.
describes the remote-control commands defined for the
instrument. At the end of
the chapter an alphabetical list of commands is given.
contains program examples for a number of typical
applications of AMIQ.
describes preventive maintenance.
gives hints on troubleshooting and contains a list of error
contains an index for the operating manual