Equipment information

Hewlett Packard 6218B Power supply
Manufacturer
Hewlett Packard
Model 6218B
Date 1982
Category Measurement instruments
Group Power supply
Description DC Power Supply Bench Series
Information
                                    DESCRIPTION

1 -2 This Power supply is completely transistorized and
suitable for either bench or relay rack operation. It is a
compact, well-regulated, Constant Voltage/Constant Current
supply that will furnish full rated output voltage at the
maximum rated output current or can be continuously adjusted
throughout the output range. The front panel CURRENT control
can be used to establish the output current limit (overload
or short circuit) when the supply is used as a constant
Voltage Source and the VOLTAGE controls can be used to
establish the voltage limit (ceiling) when the supply is
used as a constant Current source. The supply will
automatically crossover from constant voltage to constant
current operation and vice versa if the output current or
voltage exceeds these preset limits.

1-3 Either the positive or negative output terminal may be
grounded or the Power supply can be operated floating at up
to a maximum of 300 volts off ground.

1-4 A single meter is used to measure either output voltage
or output current in volts of mA. The voltage or current
range is selected by the METER SELECTION switch on the front
panel.

These manuals are available for the above equipment:

Manual Type Service and User Manual HewlettPackard-10076-Manual-Page-1-Picture
Pages 47
Size 18.76 Mbytes (19668537 Bytes)
Language english
Revision
Manual-ID/Number 5950-1928
Date 01 November 1982
Quality Scanned document, all readable.
Upload date
MD5 d4b13aeb269722be12718ac0494e54de
Downloads 385 since 30 December 2017
Information
HewlettPackard-10076-Manual-Page-1-Picture


Comments (0)

No comments yet. Be the first!

Add Comment

* Required information
1000
Captcha Image
Powered by Commentics