|JBL 6007 Amplifier|
|Category||Audio, Video, TV, Multimedia|
The Amplifier shall be single channel with an input gain control and an output level meter on the front panel. The Amplifier shall accommodate an unbalanced high impedance input, or a balanced low impedance input with an optional plug-in accessory transformer. The Amplifier shall be capable of delivering a minimum of 60 W, continuous sine wave, 20 Hz-20 kHz, into a 4 Q load. (6007: The Amplifier shall incorporate an output transformer allowing full power operation, 35 Hz-20 kHz, into an 8 Cl, 16 Cl or 70.7 V line as well as a direct output terminal for a 4 O load.) [6008: No output transformer and only a direct output terminal shall be provided, but it shall be possible to install an output transformer easily at any time.) The Amplifier shall have < 0.2% THD, 20 Hz-20 kHz, @ 60 W, direct output. (6007: The Amplifier shall have < 0.2% THD, 35 Hz-20 kHz, @ 60 W, transformer output.) Frequency response shall be ± 0.5 dB, 20 Hz-20 kHz, @ 1 W. Power bandwidth shall be 10 Hz-40 kHz. Construction of the Amplifier shall be modular. The entire Amplifier circuit, except for the power supply (6007: and output transformer) shall be mounted on a single circuit board attached to the heat sink, which assembly shall be removable from the unit with the mainframe still mounted in a rack. Cables connecting the circuit board to the mainframe shall be of a length sufficient to allow removal of the board without disconnection and shall disconnect easily at two plugs. The Amplifier shall occupy three standard EIA rack spaces and shall operate on 120/240 V AC, 50/60 Hz.
These manuals are available for the above equipment:
|JBL -- 6007 -- Service and User Manual|
|Manual Type||Service and User Manual|
|Size||2.63 Mbytes (2753701 Bytes)|
|Date||01 October 1978|
|Quality||Scanned document, all readable.|
|Upload date||29 October 2017|
|Downloads||165 since 29 October 2017|
No comments yet. Be the first!