Collins Telecommunications DL-1 Sonstiges
Hersteller:
Kein Bild verfügbar!
Vielleicht kannst du ein Bild für
Collins Telecommunications DL-1
hochladen ?
Wenn du andere Handbücher für ein
Collins Telecommunications DL-1 hast,
kannst du die Dateien hier hochladen .
Modell:
DL-1
Datum:
1966
Kategorie:
Gruppe:
Beschreibung:
100 Watt Resistor Load
Information
The DL-1 is a 100-watt resistor load for use with any
100-watt Transmitter or Transceiver such as the 32S-1,
32S-3, or KWM-2. Refer to figure 1. Use of this dummy load
allows alignment or adjustment of Transmitter circuits
without sustained radiation of an interfering carrier. The
DL-1 consists of four 50-ohm Globar resistors in a
series-parallel arrangement to provide a 50-ohm resistive
load. The DL-1 may be switched locally or remotely to select
Antenna or dummy load for connection to Transmitter output.
Jacks are provided for 6.3-volt ac 50- to 60-Hz relay coil
supply, remote switching, and Transmitter and Antenna
connections. The unit can be set on a table or desk or
mounted on any chassis or rack frame by means of the two
tapped holes on the bottom. As an alternate mounting, the
four rubber feet can be removed and the unit mounted on a
flat plate with four 6-32 screws.
Dokumenttyp:
Service- und Bedienungsanleitung
Seiten:
4
Größe:
442.67 Kbytes (453289 Bytes)
Sprache:
english
Revision:
Third Printing
Dokument-ID:
523-0106000-101311
Datum:
1966 01 01
Qualität:
Gescanntes Dokument, teilweise schwer oder teilweise nicht zu lesen.
Upload Datum:
2017 08 04
MD5:
d6eca3d7bb677095b036b535aeb7af24
Downloads:
485