Test Procedure Guide Addendum to AM8a Instruction Manual This Test Procedure Guide provides summarized information about the setup and operation of the AM8a PCM/VF Call Analyzer It consists of General Information on the operation of the unit and Application Notes. GENERAL INFORMATION...1 THE FRONT PANEL...1 START-UP AND DEFAULT SETTINGS...2 SHIFT KEY...2 THE SETUP SECTION ...2 SETUP: CONFIGURATION ...2 SETUP: EMULATE ...3 SETUP: ANALYZE...3 SETUP: AUTODIAL...3 THE DISPLAY SECTION... THE ON/OFF SECTION ...3 INPUT...3 TIMS ...3 TALK ...3 AUTO...3 FUNCTION KEYS AND STATUS LEDs ...4 SEIZE...4 START...4 RING...4 REV (Reverse) ...4 STORE/RECALL OF AM8a PARAMETERS...4 APPLICATION NOTE #1: CUSTOM CALLING FEATURES USING THE AUDODIAL FIELD...5 APPLICATION NOTE #2: DS1/T1 DROP AND INSERT...8 SETUP PROCEDURES ...8 CONFIGURE DIALED DIGITS AND DIAL TYPE ...10 DROP AND INSERT TEST...11 APPLICATION NOTE #3: DIRECT INWARD DIAL (DID)/911 ...12 SETUP PROCEDURES ...12 OPERATION...13 APPLICATION NOTE #4: SLC®96 MONITORING AND DATA LINK ANALYSIS ...14 SETUP PROCEDURES ...14 VIEW SPAN RESULTS AND ALARM CONDITIONS...15 VIEW SIGNALING EVENTS (DIGITS, TONES, SEIZURES) ...16 MODE II OPERATION...16 DATALINK MONITORING ... APPLICATION NOTE #5: DS1/T1 SIGNAL MONITORING ...18 SETUP PROCEDURES ...18 PARAMETER CHANGES...19 METER DISPLAY (A/B BIT STATES, SPAN ERRORS, ETC.) ...19 A/B SIGNALING ...20 APPLICATION NOTE #6: ORIGINATING OR TERMINATING A DS/T1 CALL ...21 SETUP PROCEDURES ...21 OPERATION...22 TERMINATING AN INBOUND CALL ...23 ORIGINATING A CALL ...23 APPLICATION NOTE #7: DIGIT ANALYSIS AND EXCEPTION REPORTING...24 SETUP PROCEDURES ...24 CONFIGURING ANALYZE THRESHOLDS ...25 OPERATION...26 DISPLAYING EXCEPTIONS...

Protocol Table Development Guide