Keithley 197 Digitale multimeter
Fabrikant:
Model:
197
Datum:
1984
Categorie:
Groep:
Omschrijving:
Autoranging Microvolt DMM

Informatie

INTRODUCTION The model 197 is a six function, 5 1/2 digit resolution autoranging Digital multimeter with a ±220,000 count LCD (Liquid Crystal Display). This A/D range is greater than the normal ±199,999 count A/D used in many 5 1/2 digit DMMs. The 5 1/2 digit resolution allows the model 197 to measure DC voltage from 1µV/count to 1000V. AC voltage and current measurements are standard in the model 197. TRMS ACV capability ranges from 1µV/count to 750V. The Model 197 measures resistance from 1mΩ to 220MΩ on seven resistance ranges. The model 197 has six current ranges that measure current from 1nA to 10A. The dB function makes it possible to compress a large range of readings into a much smaller scope. The model 197 dBm measurements are referenced to the standard 600Ω impedance but can be modified with the use of relative (REL) feature. The model 197 has two IEEE-488 Interface options: The Model 1972 and the Model 1973, These optional interfaces enhance the capabilities of the model 197 by allowing programmed control over the IEEE-488 bus. The Model 1972 also includes an analog output. The bus commands are the same for each Interface and respond to IEEE-488 protocol. FEATURES The model 197 includes the following features: 1. Six Measurement Functions—DCV, AC V, DCA, AC A, OHMS and dB all built in. 2. (REL) Relative Mode—The relative mode allows offsets to be nulled out (e.g. test lead resistance for low resistance measurements) and selects a variety of reference impedances for dB measurements. 3. Digital Calibration—A non-volatile RAM stores calibration constants and can be performed from the front panel or over the IEEE-488 bus. 4. Data Logger—A data storage buffer is included to allow up to 100 readings and minimum/maximum readings be internally stored at a user selectable rate. The buffer may be read and controlled from the front panel or over the IEEE-488 bus. In the talk-only mode, the output rate can also be programmed. 5. Autoranging—The model 197 includes a fast autoranging feature for easier measurements. 6. 5 1/2 Digit Resolution—The model 197 has a ±220,000 count A/D that surpasses the more common ±199,999 count A/D. 7. Four Terminal Ohms—These terminals are used to eliminate the voltage drop across the current carrying leads. 8. Sensitivity—The model 197 has 1µV, 1mΩ and 1nA sensitivity. The 1µV of sensitivity allows minute levels of offset, temperature etc. A 1nA sensitivity allows low current measurements without special equipment. Measure leakage, bias and offset current. A 1mΩ sensitivity allows easy low resistance measurements.

toon meer

Service-en gebruikershandleiding
Handleidingen type:
Service-en gebruikershandleiding
Pagina’s:
73
Grootte:
8.37 Mbytes (8775303 Bytes)
Taal:
english
Herziening:
Handleidingen-ID:
197-901-01
Datum:
Kwaliteit:
Gescande document, lezen deels slecht, deels niet leesbaar.
Upload datum:
2012 05 20
MD5:
09261e2c571d87fd4c3a15fc82e8c79d
Downloads:
1070
Service-en gebruikershandleiding
Handleidingen type:
Service-en gebruikershandleiding
Pagina’s:
65
Grootte:
3.08 Mbytes (3225625 Bytes)
Taal:
english
Herziening:
Handleidingen-ID:
197-901-01
Datum:
Kwaliteit:
Gescand document alle leesbaar.
Upload datum:
2018 08 21
MD5:
4dec7cba77bb532b8ce47462b6574e17
Downloads:
471

Informatie

No Schematics in this File! This manual contains information necessary for operating and servicing the model 197 Autoranging Microvolt DMM and the Model 1978 Rechargeable Battery Pack. The information is divided into the following sections. 1. Section 2 contains detailed bench operation information for the model 197. 2. Section 3 contains the information needed to verify the accuracy of the model 197. Performance verification can be done upon receipt of the unit or whenever the basic accuracy of the instrument is in question. 3. Information concerning theory of operation, maintenance and servicing is contained in Sections 4 through 6.

toon meer