Kikusui Electronics Corporation PMC35-0.5A Ander
Fabrikant:
Geen foto beschikbaar!
Misschien kan je een foto uploaden voor de
Kikusui Electronics Corporation PMC35-0.5A ?
Als je nog andere handleidingen hebt voor de
Kikusui Electronics Corporation PMC35-0.5A kun je hier de bestanden uploaden .
Model:
PMC35-0.5A
Datum:
1994
Categorie:
Groep:
Omschrijving:
REGULATED DC POWER SUPPLY
Informatie
The PMC-A series Regulated DC Power supply is an automatic
constant voltage/constant current shift type. It employs a
series regulator system and delivers a stable output wish
low noise.
• The PMC-A series, which has two bright 3-l/2digit LED
display meters, displays the output voltage and the output
current or their settings.
» The potentiometers for the output voltage and current
setting are 10 turns wire wound type, allowing
high-resolution setting and stable output.
• The output switch is an electronic switch. It causes no
chattering or noise. It can be controlled from the panel or
from a remote place.
• The output voltage and current can be remote-controlled by
an external analog signal (voltage or Resistor). The PMC-A
series can be used as a system component of an automation
system with GPIB Interface such as KIKUSUI’s PIA 3200.
ThePMC-A series can be used in a wide application field from
use in a laboratory for experiment to that on a production
line for testing.
Handleidingen type:
Gebruikershandleiding
Pagina’s:
34
Grootte:
861.98 Kbytes (882669 Bytes)
Taal:
english
Herziening:
Handleidingen-ID:
Z1 -000-582 IA000791
Datum:
Kwaliteit:
Gescande document, lezen deels slecht, deels niet leesbaar.
Upload datum:
2015 08 14
MD5:
5314dd6f1a65979aa2b0b17a320f4798
Downloads:
3436
Informatie
—— ... —* ... 8
4.2.2 Analog remote
control ... 8
4.2.3 Series operation and parallel
operation ... 12
4.2.4 Master/Slave controlled parallel
operation ... * ... 14
Chapter 5 MAINTENANCE AND
CALIBRATION ... * ... 15
5.1 Maintenance and Checking
... * ... 15
5.2
Calibration ... - ... * ...
15
5.2.1
Preparation ... * ... 15
5.2.2 Test equipment
required ... * ... 16
5.2.3 Calibration setup
·■— ... * ... 16
5.2.4 Calibration procedure
... 17
Chapter 6
SPECIFICATIONS ... ... ■· ... 19
6.2
Dimensions ...
21
6.3
Option ...
21