Tektronix DF2 Analyzer
Fabricante:
Imagen 1 de 1
Si tienes otras fotos o manuales para el
Tektronix DF2 puedes subir los archivos aquí .
Modelo:
DF2
Fecha:
1978
Categoría:
Grupo:
Descripción:
Display Formatter
Información
The DF Display Formatter provides data-domain display modes
in addition to the existing time-domain display of the 7D01
Logic Analyzer.
It adds state table displays with a comparison mode, a map
display and other operational modes as assigned to the Menu
List. The DF attaches to the left side of the 7D01
forming
a three-wide plug in assembly. This assembly operates in a
7000-series Oscilloscope mainframe to comprise a complete
16-channel logic timing-state Analyzer system.
A microprocessor controlled memory system, contained in the
DF, is capable of recording two 7D01 information records.
Portions of both information records may be displayed
concurrently in a state table presentation.
State tables are displayed in terms of either hexadecimal,
octal, or binary formats. This data may be displayed in up
to two tables of 17 lines of 16-bit words each. The
left-hand table displays data currently stored in the 7D01
memory I7D01 display). The right-hand table displays data
that h8S been transferred from previous 7D01 displays to the
DF memory (reference display). The DF compares the 2 tables
and resets the 7D01 when the 7D01 data equals the reference
data.
The map function plots a dot display of the 16 data channels
in X-Y coordinate points. Each dot location represents one
possible combination of up to 16 inputs to the 7D01,
Type manuel:
Servicio y Manual del usuario
Páginas:
152
Tamaño:
44.46 Mbytes (46614724 Bytes)
Idioma:
english
Revisión:
First Edition
Manuel-ID:
070-2478-00
Fecha:
1978 01 01
Formato:
Documento Scaned, todo legible.
Fecha de subida:
2017 12 30
MD5:
b399e8af1cba771477cac75743a6ccb1
Descargas:
714
Información
The Instruction Manual contains eleven sections. Operating
information is covered in the first four sections; servicing
information is covered in the remaining seven sections.
Schematic diagrams are located at the rear of the manual and
can be unfolded for reference while reading other parts of
the manual. The reference designators and symbols used on
the schematic diagrams are defined on the first page of the
Diagrams and Circuit Board Illustrations section.
Abbreviations used in the manuals, except in the parts list
and schematic diagrams, comply with the American National
Standards Institute Y1.1-1972 publication. The parts list is
a computer printout and uses computer-supplied abbreviations.