Dranetz Engineering Laboratories Inc. 305-PA-3009 Network Analyzer
Fabricante:
Modelo:
305-PA-3009
Fecha:
1976
Categoría:
Grupo:
Descripción:
Network Analyzer

Información

PURPOSE The purpose of this Plug-In is to expand the usefulness of Dranetz Series 305 phasemeters by adding the ability to measure the voltage of both inputs in either volts or dB reference 1 Volt = 0 db. The ratio in dB of the "Signal” input with respect to the "Reference" is also measured, 1.3 CHARACTERISTICS The detailed characteristics of the 305~PA~3009 when used in a series 305 phasemeter are specified by Table 1.1 which follows: TABLE 1.1, 305-PA-3009 SPECIFICATIONS INPUT LEVEL RANGE: 10 mV rms to 40 V rms both inputs. INPUT IMPEDANCE: 1 Megohm plus 40 pf both inputs, usable with standard Oscilloscope probes. INPUT FREQUENCY RANGE: 2 Hz to 700 kHZ FUNCTIONS: Amplitude of reference input in volts or dR ref 1 volt, Amplitude of signal input in volts or dB ref 1 volt. Phase angle of signal input with respect to reference input, and Ratio of signal input to reference input in dB, The function to be displayed is selected by a switch on the front panel of the Plug-In. ANALOG OUTPUTS: Four Outputs are simultaneously available at the rear of the. phasemeter main frame* They are proportional to Reference input level (in either volts or d b) , Signal input level (in either volts or d b ) , Phase Angle of Signal with respect to reference* and ratio of signal to Reference In db. The sensitivity of all db outputs is 10 mv/db, The sensitivity of the phase angle Output is 10 mv / degrees (a positive, output indicates that Signal leads Reference). The voltage amplitude output« have one of 3 sensitivities depending on which voltage range is in use* Sensitivity Is 10 volts/ volt in the mv x 1 range, 1 volt/volt in the mv x 10 range and 0*1 volt/volt in the volts *10 range.

ver más

Servicio y Manual del usuario
Type manuel:
Servicio y Manual del usuario
Páginas:
36
Tamaño:
992.82 Kbytes (1016652 Bytes)
Idioma:
english
Revisión:
Manuel-ID:
TM-102,848
Fecha:
1976 09 01
Formato:
Documento Scaneds, en parte leyendo mal, no parcialmente legible.
Fecha de subida:
2017 08 11
MD5:
f0e97ca75ebdd086a907032f20368e9e
Descargas:
403

Información

1. General Information 1.1 Introduction 1.2 Purpose 1.3 Characteristics 2» Operation 2.1 General 2.2 Connector Identification 2.3 Operating Procedure 3. Theory of operation 3.1 General 3.2 Block'Diagram Discussion A, Performance Test 4*1 General 4.2 Test Procedure 5* Maintenance 5.1 General 5.2 Adjustment Procedure 5.3 Repair Proceduro 6. MAIN FRAME MODIFICATION 6.1 PURPOSE 6.2 MODIFICATION PROCEDURE 7. DRAWINGS INCLUDED 102,2**3 ASSY CARDS 3^4 102,255 SCHEMATIC CAKDS 3&4 102,848 ASSY 305PA3009 102,349 ASSY CARDS 1&2 102,050 SCHEMATIC CARDS U2 102,623 SCHKMATIC CARD 5 102,620 ASSY CARD 5

ver más