California Instruments 501TC Fuente de alimentación
Fabricante:
Modelo:
501TC
Fecha:
1986
Categoría:
Grupo:
Descripción:
Power Source

Información

The California Instruments Model 501TC Power Amplifier is a solid state, high performance, low distortion power source that provides up to 500 VA output when used with the proper Plug-In Oscillator. The Model 501TC Power Source is illustrated in Figure 1-1. Full power output is available in two different voltage ranges and over the frequency range from 45 Hz to 5 KHz. These full power voltage ranges are: 1) 105 to 135 volts rms for normal single phase 115 volt applications and for three phase 208 to 234 volt line-to-line applications. 2) 210 to 270 volts rms for normal single phase 230 volt applications and for three phase 208 to 270 volt applications where open Delta operation is acceptable. For two phase and three phase operation, at least two power amplifiers must be combined together with the applicable multi-phase Oscillator. Two power amplifiers will provide a total of 1000 VA two phase power (Model 1000TC/2-2), or 1000 VA of three phase power (Model 1000TC/2-3D) in the open Delta configuration. Three power amplifiers will provide 1500 VA of three phase power in the wye configuration (Model 1500TC/3-3).

ver más

Servicio y Manual del usuario
Type manuel:
Servicio y Manual del usuario
Páginas:
52
Tamaño:
11.00 Mbytes (11533995 Bytes)
Idioma:
english
Revisión:
Manuel-ID:
Fecha:
Formato:
Documento Scaneds, en parte leyendo mal, no parcialmente legible.
Fecha de subida:
2015 12 20
MD5:
530ec3bda3b2950e81ed0285c4c550a4
Descargas:
1151

Información

GENERAL DESCRIPTION PACE 1. 1 INTRODUCTION 1 1.2 GENERAL DESCRIPTION 1 1.3 ACCESSOR Y EQUIPMENT 1 INSTALLATION AND OPERATION 2. 1 UNPACKING 5 2.2 POWER REQUIREMENTS 5 2.3 CIRCUIT BREAKER REQUIREMENTS 6 2.4 OUTPUT VOLTAGE RANGE AND 6 METER RANGE 2.5 ACCEPTANCE TEST PROCEDURE 6 2.6 MECHANICAL INSTALLATION 8 2.7 INPUT POWER WIRING 8 2.8 OUTPUT POWER WIRING 8 2. 9 FRONT PANEL CONTROLS 8 2. 10 OPERATION OVER EXTENDED FREQUENCY 9 RANGE THEORY OF OPERATION 3.1 GENERAL H 3.2 DETAILED CIRCUIT DESCRIPTION 11 CALIBRATION PROCEDURE 4.1 GENERAL 17 4.2 TEST EQUIPMENT REQUIRED 18 4. 3 INITIAL ADJUSTMENTS 18 4.4 AC LINE INPUT POWER AND OVERLOAD 19 ADJUSTMENT 4.5 VOLTAGE, POWER OUTPUT AND HARMONIC 22 DISTORTION 4.6 LINE REGULATION 22 4.7 LOAD REGULATION ADJUSTMENT 24 4.8 AMPLITUDE STABILITY 25 4.9 FREQUENCY RESPONSE 25 4. 10 AC NOISE LEVEL 25 4. 11 0. 7 LAGGING POWER FACTOR 26 4. 12 0.7 LEADING POWER FACTOR 27 MAINTENANCE AND TROUBLESHOOTING 5.1 GENERAL 30 5.2 TROUBLESHOOTING 30 CIRCUIT DIAGRAMS 6.1 GENERAL 31 6.2 REFERENCE DESIGNATIONS 31 REPLACEABLE PARTS 7.1 GENERAL . 36 7.2 ORDERING INFORMATION 36 PARTS LIST APPENDIX A CODE LIST OF MANUFACTURERS

ver más