Kenwood TS-520 Transceiver
Manufacturer:
Image 1 of 2
Image 2 of 2
If you have any other photos or manuals for the
Kenwood TS-520 you can upload the files here .
Model:
TS-520
Date:
Category:
Group:
Description:
SSB Transceiver
Information
KENWOOD TS-520
The TS-520 is a highly sophisticated solid state amateur
radio Transceiver employing only three vacuum tubes.
Operating on all amateur bands between 3.5 and 29.7 MHz,
this unit is constructed modularly. All major electronic
circuits are wired on easily removed or installed circuit
boards. The TS-520 includes many built-in features usually
found as extras on other transceivers. Included in the
equipment are a VOX circuit, a 25 kHz crystal calibrator, an
RIT circuit, and an effective noise blanker. The TS-520 also
includes automatic gain control (AGC), automatic level
control (ALC), provisions for break-in CW with sidetone, a
speech processor, and built-in power supplies.
Designed for operation on SSB or CW, the TS-520 delivers
more than 200 watts PEP input. The low power consumption of
the TS-520
resulting from its solid state design, makes the
Transceiver ideal for portable and mobile operation. Any
complicated electronic equipment will be damaged if operated
incorrectly, and this Transceiver is no exception. Please
read all of the operating instructions before putting the
TS-520 on the air.
Manual type:
User Manual
Pages:
56
Size:
4.58 Mbytes (4807486 Bytes)
Language:
english
Revision:
Manual ID:
Date:
Quality:
Scanned document, all readable.
Upload date:
2018 05 20
MD5:
0b107465c262e7bce2f650664e6ac10a
Downloads:
836
Information
CONTENTS
TS-52Q SPECIFICATIONS ... 4
SECTION 1 INTRODUCTION ... 6
1.1 KENWOOD TS-520
.1.2 Requirements for Operation %
SECTION 2 INSTALLATION ... : ... 8
2.1 Unpacking;,
2.2 OperatingLocation
2.3 Cabling,;-;
SECTION 3"t,r jQPER^jfNG CONTROLS ... ... . . ..
4.9 Transmitter Tuning
4.10 SSB Operation
4.11 CW Operation
4.12 0pöratibnwith;aLihear'Amplifier
4.13 Fixéd Frëquency Operation
4.14 Internal Cross Channel Operation
4.15 Mobile Operation ^4.16 DX Operation Î4.17 SSTV Operation
4.18 Operation with a Phone Patch v 3
4.19 Novice Operation
5 CIRCUIT DESCRIPTION ...
5.1 General Description
5.2 Carrier Board
5.3 Generator Board
5.4 IF Board
5.5 NB Board
5.6 RF Section
5.7 Marker Board
5.8 AF Board
5.9 VOX Board
5.10 VFO Board
5.11 Fixed Channel - AVR Board
5.12 Rectifier Board
5.13 HV Board
5.14 Indicator Board
5.15 Final Power Amplifier Section
6 MAINTENANCE AND ALIGNMENT ...
6.1 General Information
6.2 Accessories
6.3 Receiver RF Section
6.4 Noise Blanker Board Alignment
6.5 IF Board Alignment
6.6 Fixed Channel - AVR Board Alignment
6.7 Drive Coil Alignment
6.8 Carrier Balance Adjustment
6.9 Transmitter Neutralization
6.10 VFO Calibration
6.11 Crystal Calibrator Alignment
6.12 Replacing the Fuse
6.13 Cleaning
6.14 Replacement Parts
7 TROUBLESHOOTING ...
7.1 General Information
7.2 Transmitter and Receiver Circuits
7.3 Receiver Section
7.4 Transmitter Section
8 VOLTAGE MEASUREMENTS ...
8.1 Tube Voltage Measurements
8.2 Transistors
8.3 1C
TRANSISTOR BASE DIAGRAM ... 47
TOP VIEW OF THE TS-520 ... 48
BOTTOM VIEW OF THE TS-520 ... 49
DC TO DC MODULE SCHEMATIC ... . 50
TS-520 SCHEMATIC ... 51
RF SECTION SCHEMATIC ... 52
Manual type:
Service Manual
Pages:
37
Size:
3.01 Mbytes (3157712 Bytes)
Language:
english
Revision:
Manual ID:
Date:
Quality:
Scanned document, all readable.
Upload date:
2018 05 20
MD5:
d46dd1c2d5f79560ce1213c32f620cbd
Downloads:
2073