Equipment information

Racal SERIES 1250 Interface
Model SERIES 1250
Date 2002
Category: Measurement instruments
Group Interface
Description Universal Switch Controller
                                    The 1250 Universal Switch Controller allows signals to be
switched in a single system from DC to 26.5GHz. The 1250
Series is a general purpose switching system designed for both
manual and automatic test systems. Low level, power, R.F. and
microwave switching requirements are addressed by the switch
modules available in the 1250 Series.
The 1250 is designed for use in automatic test systems, but
local control of the switching system is supported by Option 90,
which supplies an intelligent front panel with a display and
keyboard. Refer to Figures 1-1 and 1-2 for illustrations of the
1250 front panel and Option 90, the intelligent front panel,

These manuals are available for the above equipment:

Manual Type User Manual Racal-7286-Manual-Page-1-Picture
Pages 218
Size 1.46 Mbytes (1530254 Bytes)
Language english
Manual-ID/Number 980609
Date 21 March 2002
Quality Electronic document, no scan, very well readable.
Upload date
MD5 5b098558435b0cc6175cb1ef4f3b1f54
Downloads 63 since 10 October 2015
This manual provides the information necessary to install and
operate the Racal-Dana Model 1250 Universal Switch Controller.
Section two (Installation) provides the procedures necessary to
unpack and inspect the 1250, install the intelligent front
install 1250 Series switch modules in the chassis and connect
the 1250 to the GPIB. Section three (Operation) provides the
command codes and keystrokes required in both local and
remote control of the 1250.

Comments (0)

No comments yet. Be the first!

Add Comment

* Required information
Captcha Image
Powered by Commentics