PM 5193 is a cost-effective multifunctional combination of
programmable frequency synthesizer and function generator.
The microprocessor control enables simple and rapid
operation and allows parameter sets to be stored and
recalled. Up to 10 set-ups may be stored in non-volatile
registers, each of them containing parameters to set wave
form, frequency, amplitude, dc-offset and modulation modes
like AM, FM, SWEEP, BURST and GATING.
PM 5193 frequency range covers 111/2 decades, from 0,1 mHz
to 50 MHz. And to make working with this high precision
instrument as simple as possible 8 different wave forms are
directly selectable. That includes stadard functions like
sine, square wave, sawtooth and ramps, as well as important
extras like rectangular pulses — positive and negative — and
Precision and stability are essential factors in this
instrument. With a crystal oscillator that serves as a
reference standard for all generated frequencies, a high
standard of accuracy is achieved. Together with outstanding
long-term stability, ensuring that today's signals can
always be reproduced precisely.
Frequency resolution is 8 digits, so that full advantage can
be taken of the instruments high precision, for example in
the identification and measurement of phenomena occuring at
precisely defined frequencies.
IEEE/IEC bus compatibility adds an important extra dimension
to PM 5193's versatility. All functions are remotely
selectable, and all settings and status data can be
transmitted to a remote controller and recalled whenever
Completing its impressive specification, PM 5193 combines
powerful user features with operation that could not be
simpler. The front panel is divided into clear, separate
keypad areas, and three LED displays show together with the
key LEDs frequency, modulation parameters, output level and
In addition to this manual please find attached an
operating/programming card for short-form operating
instruction of the instrument.
For adequate customer support and in order to facilitate the
service, a test program is built in. Service is done on
component level, so no complete module must be exchanged.