Equipment information

Wavetek 801 Generator
Model 801
Category: Measurement instruments
Group Generator
Description 50 MHz PULSE GENERATOR
                                    The Model 801 is a 50 MHz general purpose laboratory pulse
generator. The instrument gives you full control in primary
pulse triggering and shaping plus simultaneous TTL, ECL, ECL
and sync pulses. The primary pulse output has
controllability in offset and independent rise/fall
durations, as well as pulse width, pulse delay and a choice
of positive, negative or complementary outputs. The TTL, ECL
and ECL are of fixed levels and rise times that are standard
for use with compatible devices. The primary pulse has
minimum rise and fall times of 7 ns and a maximum of 250 ms.
The output is ±20 volts with 50Ω source impedance which
provides ±10 volts into a 50Ω load. Upper and lower pulse
levels are fully adjustable through ±20 volts.
External triggering can be set to any point of the rising or
trailing edge of the trigger signal. Single pulses or pulse
pairs may be triggered; pulse width may be trigger
controlled; continuous pulses may be gated and a precise
number of pulses may be triggered for a ‘burst’ output.
Manual and external triggering is indicated by an LED on the
front panel for rapid visual set of trigger level.

These manuals are available for the above equipment:

Manual Type Wavetek-6392-Manual-Page-1-Picture
Pages 9
Size 571.91 Kbytes (585636 Bytes)
Language english
Revision C
Quality Scanned document, all readable.
Upload date
MD5 760885252cc290b311d92487c5c7118b
Downloads 208 since 17 November 2014
Only a few pages from the Instruction manual.

Comments (0)

No comments yet. Be the first!

Add Comment

* Required information
Captcha Image
Powered by Commentics