Equipment information

Wavetek 1003 Generator
Manufacturer
Wavetek
Model 1003
Date 1977
Category: Measurement instruments
Group Generator
Description SWEEP/SIGNAL GENERATOR
Information
                                    The Wavetek 1000 Series Sweep/Signal generators are single
band instruments covering the frequency range from 500 KHz
to 1.4 GHz. All units utilize the same, Front Panel, Harness
and Power Supply with the balance of the circuits contained
in Plug-In Modules. However, it is not intended that one
model be converted
to another. The plug-in concept simplifies maintenance
problems and provides marker circuits which can be
customized to specific applications. A Rear Panel Con nector
permits remote programming of Center Frequency, Sweep Width
and Output Level, plus. External Amplitude and Frequency
Modulation.

These manuals are available for the above equipment:

Wavetek -- 1003 -- Service and User Manual
File name Wavetek-6363-Manual-Page-1-Picture
Manual Type Service and User Manual
Pages 77
Size 5.97 Mbytes (6263685 Bytes)
Language english
Revision revised
Manual-ID/Number
Date April 1977
Quality Scanned document, all readable.
Upload date
MD5 bb6322721f7d6c0b5456cad22d34d599
Downloads 450 since 09 November 2014
Information
This manual provides descriptive material and instructions
for the installation, operation, maintenance, and repair of
the WAVETEK Model 1001A to 1005 Sweep/Signal Generator.

SECTION 1 -GENERAL INFORMATION
1.1 INTRODUCTION
1.2 SPECIFICATIONS
1.3 OPTIONS
1.4 ACCESSORIES
SECTION 2-INSTALLATION
2.1 MECHANICAL INSTALLATION
2.2 ELECTRICAL INSTALLATION
SECTION 2—OPERA TING INSTRUCTIONS
31 INTRODUCTION
3.2 DESCRIPTION OF FRONT PANEL
3.3 DESCRIPTION OF REAR PANEL
3.4 TYPICAL OPERATING SET UP
3.5 SPECIAL OPERATING NOTES
3.6 PROGRAMMING
SECTION 4 - CIRCUIT DESCRIPTION
4.1 INTRODUCTION
4.2 SIMPLIFIED BLOCK DIAGRAM
4.3 POWER SUPPLY
4 4 SWEEP RATE (MODULE M1H)
4.5 SWEEP DRIVE (MODULE M2G)
4.6 SWEEP OSCILLATOR FOR MODEL 1001A and 1002 (MODULE M9G
and M9H)
4 7 OUTPUT AMPLIFIER FOR MODEL 1001A and 1002 (MODULE M1 OF
and M10G)
4.8 SWEEP OSCILLATOR FOR MODEL 1003 1004. and 1005 (MODULE
M9R S and'T)
49 MARKER ADDER (MODULE M5G)
4.10 MARKERS (MODULE M6s)
SECTION 5 MAINTENANCE
5.1 INTRODUCTION
5.2 SERVICE INFORMATION
5.3 PERFORMANCE CHECKS
5.4 CALIBRATION PROCEDURE
5.5 TROUBLESHOOTING
SECTION 6 -SCHEMATICS & PARTS LIST
6.1 INTRODUCTION
6.2 MANUFACTURERS CODE
6.3 SCHEMATIC NOTES
6.4 ABBREVIATION CODE SCHEMATICS AND PARTS LIST
Wavetek-6363-Manual-Page-1-Picture
Start Free Download


Comments (0)

No comments yet. Be the first!

Add Comment

* Required information
1000
Enter the word shark backwards.
Powered by Commentics