Keithley 7063 Interface
Manufacturer:
No picture available!
Maybe you can upload a photo for the
Keithley 7063 ?
If you have any other manuals for the
Keithley 7063 you can upload the files here .
Model:
7063
Date:
1984
Category:
Group:
Description:
RF Scanner Card
Information
The Model 7063 is an RF scanner card that switches RF
signals (up to 500MHz) from one channel to another. All
channels switched are terminated into 50tl when not
selected. When a channel is closed, the RF signal is routed
from the input to the output. The Model 7063 works in
conjunction with a scanner mainframe such as the Keithley
model 705 or model 706.
The Model 7063 incorporates two 1X5, switches on each card.
Each switch has a separate common (ground). This allows two
signals to be switched at the same time. One 1X5 switch
could be cascaded with the other 1X5 switch (on the same
card) for a 1 X 10 switch configuration. Thus, the Model
7063 is configurable for several different switch
configurations.
Specified relay life is greater than 100,000 closures.
Cables are routed from the rear of the card. The front plugs
into the mainframe (e.g. model 705 or model 706). The
mainframe must be in the matrix mode or 2-pole mode to
operate the channels on the Model 7063 card. BNC connectors
allow easy connections to input/output signal paths.
Manual type:
Service and User Manual
Pages:
30
Size:
742.69 Kbytes (760517 Bytes)
Language:
english
Revision:
A
Manual ID:
7063-901-01
Date:
Quality:
Scanned document, all readable.
Upload date:
2014 03 02
MD5:
674717ccb8a646a79f7258f6045355fc
Downloads:
760
Information
SECTION 1 GENERAL INFORMATION
1.1
Introduction ... 1
1.2 Warranty
Information ... 1
1.3 Manual
Addenda ... 1
1.4 Safety Symbols and Terms
... 2
1.5 Unpacking and
Inspection ... 2
1.6
Specifications ... 2
SECTION 2- OPERATION
2.1 Introduction
... 3
2.2 Safety Precautions
... 3
2.3
Wiring ... 3
2.3.1 t of 11 Switch
... 4
2.3.2 I of 11
Matrix ... 6
2.4 Installation
... 8
2.4.1 Removal
... 8
2.5
Operation ... 8
2.6 Switch
TerminoloRy ... 10
SECTION 3—SERVICE INFORMATION
3.1 Introduction
... 13
3.2 Required Test
Equipment ... 13
3.3 Performance Verification
Procedure ... 14
3.3.1 Insertion
Loss ... 14
3.3.2 Channel
Isolation ... 14
SECTION 4—REPLACEABLE PARTS
4.1
Introduction ... 17
4.2 Replaceable
Parts ... 17
4.3 Ordering
Information ... 17
4.4 factory
Service ... 17
4.5 Component Layout and Schematic Diagram ... 17