Geräte Informationen:

Thurlby Thandar Instruments TTI TG300 Series Generator
Thurlby Thandar Instruments TTI
Modell: TG300 Series
Datum: 2009
Kategorie: Messgeräte
Gruppe: Generator
Beschreibung: 3MHz Function Generators
                                    The TG300 series are precision 3MHz function generators with waveforms of sine, triangle, ramp.
pulse and DC from a variable amplitude 50Ω or 600Ω output. A TTL/CMOS auxiliary output is also
The frequency range is 0·03Hz to 3MHz selected by a seven decade range multiplier and
calibrated vernier. Both the frequency vernier and the sweep input can give 1000:1 frequency
change within a selected range. A 10:1 symmetry range permits ramp and pulse waveforms to be
The generator output level is 20Vpk-pk maximum from a 50/600Ω source. The level is set via a
switched attenuator plus vernier with a total range of >80dB. DC offset is vernier adjustable over
a ±10V range with centre detent for 0V. Waveform quality is good at all frequencies and signal
All models feature a large liquid crystal display shows frequency and amplitude simultaneously.
Good resolution and a fast display update rate are maintained at all frequencies.
The TG330 also has internal LIN/LOG sweep with sweep output and AM. Amplitude modulation of
up to 100% is possible using the internal 400Hz oscillator or an external source.
On the TG320 and TG330 the display can also be used as an external 120MHz frequency meter
with up to 7-digit resolution.
Additional display annunciators indicate generator status when sweep, AM, etc. are in use.

Folgende Anleitungen sind hier verfügbar:

Dokumenttyp: Bedienungsanleitung Thurlby-4731-Manual-Page-1-Picture
Seitenanzahl: 43
Dateigröße: 823.39 Kbytes (843150 Bytes)
Sprache: Englisch
Revision: Issue 6
Dokument-ID/Nummer: 48591-0820
Datum: 2009
Qualität: Elektronisches Dokument, kein Scan, sehr gut lesbar.
Upload Datum:
MD5: da2adce8df0fb0ab6441aa7ecffd16a5
Downloads: 165 seit dem 02 November 2013
Introduction 2
Specification 3
Safety 8
Installation 9
Operation 10
Calibration and Maintenance 13
Instructions en Francais
Sécurité 14
Installation 15
Fonctionnement 16
Calibrage et maintenance 20
Bedienungsanleitung auf Deutsch
Sicherheit 21
Installation 22
Betrieb 23
Kalibrierung und Wartung 27
Istruzioni in Italiano
Sicurezza 28
Installazione 29
Funzionamento 30
Calibrazione e Manutenzione 34
Instrucciones en Español
Seguridad 35
Instalación 36
Funcionamiento 37
Calibrado y Mantenimiento 41

Comments (0)

No comments yet. Be the first!

Add Comment

* Required information
Captcha Image
Powered by Commentics