Geräte Informationen:

Thurlby Thandar Instruments TTI LD300 Sonstiges
Thurlby Thandar Instruments TTI
Modell: LD300
Datum: 2009
Kategorie: Messgeräte
Gruppe: Sonstiges
Beschreibung: 300W DC ELECTRONIC LOAD
                                    This DC electronic load is intended for use in investigating the behaviour of many different types of DC power sources such as batteries, solar cells, fuel cells or wind generators, as well as electronic power supply units.
It operates over the current range 0 to 80 Amps and voltage range 0 to 80 Volts with a power dissipation capability of up to 300 Watts. It is designed to have very low internal resistance to allow operation at high currents with low voltage drop. The voltage of the source can be sensed either internally for convenience or externally for better accuracy.
A low voltage dropout facility is provided to protect sources such as batteries from damaging levels of discharge by reducing the load current when the source voltage falls below the dropout threshold.
The unit provides five different operating modes: constant current, constant voltage, constant power, constant resistance and constant conductance. The value of the chosen constant parameter is set by 10-turn controls on the front panel.
An internal transient generator can repeatedly switch the load between two different operating levels set on separate 10-turn controls. The frequency and duty cycle of the transients can be set over a wide range. The transients can also be initiated by an external logic signal. The transitions between the levels have a true linear slewing characteristic in all modes; the slew-rate is adjustable over a wide range.
An external control voltage can also be used to set the level of the load. Any desired waveform can be applied; the internal slew rate control circuit remains active.
Two 4-digit meters can be switched to display either the level settings, the transient generator parameters, the measured values of Volts & Amps or the equivalent Watts & Ohms. A monitor output providing a voltage proportional to the current flowing allows the behaviour of a source to be viewed on an oscilloscope or external meter.
The unit is fully protected against excessive current, power dissipation or internal temperature, and minimises audible noise by automatically controlling the fan speed according to the power dissipation.

Folgende Anleitungen sind für obiges Gerät verfügbar:

Thurlby Thandar Instruments TTI -- LD300 -- Bedienungsanleitung
Dateiname: Thurlby-4722-Manual-Page-1-Picture
Dokumenttyp: Bedienungsanleitung
Seitenanzahl: 112
Dateigröße: 1.31 Mbytes (1377740 Bytes)
Revision: Issue 6
Dokument-ID/Nummer: 48511-0630
Datum: 2009
Qualität: Elektronisches Dokument, kein Scan, sehr gut lesbar.
Upload Datum:
MD5: 271d4d36b5538f570108d1e530fb3668
ed2kID: c9a45abe3251c03e0128cb560ecec9a5
Downloads: 261 seit 02 November 2013
Introduction 2
Specification 3
Safety 9
Installation 10
Connections 11
Operating Controls 13
Operation 16
Application Notes 22
Remote Control 27
Maintenance 28
Instructions en Francais 29
Bedienungsanleitung auf Deutsch 49
Istruzioni in Italiano 71
Instrucciones en Español 91
Kostenlos herunterladen

Kommentare (1)

Thema: Thurlby Thandar Instruments TTI LD300
0/5 (0)
Alfred sagt...
need to use it to test a battery
24 März 2015 14.23
Seite 1 von 1

Kommentar Hinzufügen

* Pflichtfeld
(wird nicht veröffentlicht)
Bold Italic Underline Strike Superscript Subscript Quote Line Bullet Link Email Image Video
Smile Sad Huh Laugh Mad Tongue Crying Grin Wink Scared Cool Sleep Blush Unsure Shocked
What is the next number: 10, 12, 14, ..?
Die Antwort lautet:
Informiere mich via E-Mail über neue Kommentare.
Meine Daten auf diesem Computer.
Powered by Commentics