Geräte Informationen:

Ailtech 7320 Sonstiges
Hersteller:
Ailtech
Modell: 7320
Datum: 1978
Kategorie: Messgeräte
Gruppe: Sonstiges
Beschreibung: System Noise Monitors
Informationen:
                                    The System Noise Monitors described in this Instruction
Manual (7310 and 7320) are functionally identical. Each
provides a readout of the Noise Figure of a unit under
test (UUT) when connected in a valid measurement setup.
The minimum test setup consists of a SNM, the UUT, and a
solid state noise source of the AILTECH 7600 series.
The 7310 and 7320 have optional meter scales which
provide an Operating Noise Temperature readout in
lieu of Noise Figure.

The 7310 and 7320 SNM’s are referred to as analog
units because the readout is by a meter with two ranges.
Range selection is made by means of a front panel
switch. AILTECH also manufactures the 7360 and 7370
which indicate Noise Figure by means of a three-digit
LED display and are generally referred to as digital
units.

The 7310 is 7½ inches wide and is intended for bench-top
use while the 7320 is approximately 17 inches wide and is
intended for rack mounting. The optional Rack Mount Angle
Brackets (Option 11) must be attached for mounting
in a standard 19 inch rack.

Folgende Anleitungen sind für obiges Gerät verfügbar:

Ailtech -- 7320 -- Service- und Bedienungsanleitung
Dateiname: Ailtech-4271-Manual-Page-1-Picture
Dokumenttyp: Service- und Bedienungsanleitung
Seitenanzahl: 48
Dateigröße: 1.35 Mbytes (1420405 Bytes)
Sprache: Englisch
Revision: B
Dokument-ID/Nummer:
Datum: Juli 1978
Qualität: Gescanntes Dokument, alles ist lesbar.
Upload Datum:
MD5: 0b4f0635a907f9ba1ca88e1ddd578fe3
ed2kID: 9ea8819e7d0469bff259e63e57aa9258
Downloads: 170 seit 16 März 2013
Informationen:
Chapter I-General Information

1-1. Introduction	1-1

1-3. General Description	1-1

1-7. Safety Precautions	1-1

1-10. Technical Specifications	1-1

1-12. Functional Description	1-5

1-13. General	1-5

1-15. The Noise Monitor in a Typical Application	1-5

1-17. Auxiliary Outputs	1-6

1-19. Options	1-6

1-21. Accessories	1-7

1-22. Noise Generators	1-7

1-23.	Precision Attenuation	1-9

1-24.	Test Equipment	1-10

Chapter 11-Installation

2-1.	Introduction	2-1 2-3. Unpacking, Inspection and Damage Claims	2-1 2-5. Ancillary Items	2-1 2-7. Rack Mounting	2-1 2-9. Preparation for Use	2-1

2-11.	Initial Checkout	2-2

2-14.	General	2-2 2-16. Checkout Procedures	2-2

Chapter Ill-Operating Instructions

3-1.	General	3-1 3-3. Description of Operating Controls, Indicators and Connectors	3-1 3-5. Set-up Procedures	3-1 3-8. Interconnections	3-1 3-17. Excess Noise Ratio Setting	3-5 3-21. Establishing the Correct Signal Levels	3-5 3-27. Operation	3-7
3-31. Use of Auxiliary Outputs	3-9

3-33. Signal Monitor, Jl, Pin 4	3-9

3-35. External Meter, Jl, Pins 6 and 7	3-9

3-37.	Recorder Output, Jl, Pin 8	3-10

3-39.	Manual Noise Figure (Temperature) Measurements	3-10

Chapter IV-Theory of Operation

4-1.	Introduction	4-1 4-3. General Theory	4-1

4-4.	Noise Figure Theory	4-1 4-6. Noise Figure Measurement	4-2 4-8. Operating Noise Figure and Temperature Measurement	4-4

4-11. Functional Description (Automatic Noise Measurement)	4-5

4-15. Circuit Descriptions	4-8

4-17. IF Amplifier	4-9

4-22. Square Law Detector --------------—-------------------------4-9

4-24. Variable Gain Amplifier	4-9

4-25. Synchronous Integrator and Meter Amplifier	4-9

4-26. AGC Amplifier	4-9

4-31. Timing Signal Generator	4-10

4-39.	Power Supply Board	4-13 4-41. +12 Volt Regulator	4-14 4-42. -12 Volt Regulator	4-14

4-43.	+28 Volt Noise Source Supply	4-14

Chapter V-Maintenance and Adjustments

5-1.	General	5-1 5-3. Performance Verification	5-1

5-6.	Minimum Operating Level	5-1 5-7. Noise Generator Power	5-2 5-8. Accuracy	5-2

5-10. Checks and Adjustments	5-3

5-13. Power Supply Adjustments	5-5

5-14. IF Adjustments	5-5

, 5-16. Preliminary	5-5

5-17. Procedure	5-6
5-18.	Meter Adjustments		5-6
5-20.	Auxiliary Output Adjustments		5-6
	5-22.	Signal Monitor	5-6
	5-23.	Recorder Output	5-7
5-24.	Troubleshooting		5-7
5-26.	General Information		5-7
	5-27.	Tools	5-7
	5-28.	Transistors	5-7
	5-29.	Integrated Circuits	5-8
	5-30.	Logic Family	5-8
	5-31.	Logic Circuits	5-8
	5-32.	Analog Gates	5-8
	5-33.	Operational Amplifiers	5-8
	5-34.	Printed Circuit Boards	5-8
	5-37.	Printed Circuit Board Connectors	5-8
	5-38.	Front Panel Lamps	5-13
	5-39.	ENR Thumbwheel Switch	5-14
5-40.	Troubleshooting Procedures		5-14
5-44.	Factory Service		5-14
Chapter Vi-Spare Parts			
6-1.	General		6-1
	6-2.	Recommended Spare Parts	6-1
	6-3.	Replaceable Spare Parts	6-1

Ailtech-4271-Manual-Page-1-Picture
Kostenlos herunterladen


Ailtech -- 7320 -- Service- und Bedienungsanleitung
Dateiname: Ailtech-5744-Manual-Page-1-Picture
Dokumenttyp: Service- und Bedienungsanleitung
Seitenanzahl: 102
Dateigröße: 3.50 Mbytes (3669192 Bytes)
Sprache: Englisch
Revision:
Dokument-ID/Nummer:
Datum: Juli 1978
Qualität: Gescanntes Dokument, alles ist lesbar.
Upload Datum:
MD5: cba1429e6844dfbef00accb0ffe62959
ed2kID: d9b5bd887fe2c6edbbeaa5bc04ccab17
Downloads: 112 seit 22 April 2014
Informationen:
This Instruction Manual is for the AILTECH 7310 and AILTECH
7320 System Noise Monitors
(SNM), figure 1-1, and contains physical and functional
descriptions, installation and inspection
procedures, operating and maintenance instructions, and a
parts list for each model. All
schematics, electrical and assembly drawings are included,
as are appendices for the available optional
features. Unless otherwise stated, the information provided
herein applies to both models.
Ailtech-5744-Manual-Page-1-Picture
Kostenlos herunterladen


Kommentare

Noch keine Kommentare vorhanden.

Kommentar Hinzufügen

* Pflichtfeld
(wird nicht veröffentlicht)
 
Bold Italic Underline Strike Superscript Subscript Quote Line Bullet Link Email Image Video
 
Smile Sad Huh Laugh Mad Tongue Crying Grin Wink Scared Cool Sleep Blush Unsure Shocked
 
1000
Enter the third word of this sentence.
 
Die Antwort lautet:
 
Informiere mich via E-Mail über neue Kommentare.
 
Meine Daten auf diesem Computer.
 
 
Powered by Commentics