|Fluke 8506A Digital Multimeter|
The 8505A and 8506A Digital Multimeters are Fluke's most advanced bench/system DMMs. Both models excel in dc accuracy, resolution, versatility and speed. The 8506A uses a fast thermal rms sensing technique for measuring ac which very significantly advances the state-of-the-art for ac measurements using a system DMM. It is several times more accurate than the calculating type of true-rms converter and is unmatched by any other DMM. Basic ac accuracy uncertainty is reduced to 120 parts per million, 24 hours for frequencies from 40 Hz to 20 kHz. That approximates the accuracy you can expect using traditional thermal transfer techniques that typically take several minutes for each measurement. Short term stability is 25 ppm. Accuracy is specified from 10 Hz to 1 MHz and non-sinusoidal waveforms having crest factors as high as 8 to 1 can be measured with full 90-day accuracy. Software Calibration Both the 8506A and 8505A have a “software calibration” feature that makes it easy to store correction factors for every range of any measurement function. You can update the 24-hour accuracy specifications daily, or whenever the need arises without having to remove the covers. Nor do you need to use a cardinal point standard for a reference. Any reference having a suitably accurate value between 60% of range and full scale will do. This "software calibration” is managed with a few keystrokes on the front panel or even remotely when used as part of a test and measurement system. Measurement Speed Most system DMM manufacturers use an integrating technique for A-to-D conversion. That means there must be a compromise between resolution and reading speed. The 8505A and 8506A use a Fluke patented “recirculating remainder” technique for A-to-D conversion that does not compromise 6Ίζ digit resolution at reading speeds up to 500 per second for dc voltage measurements. Front or rear measurement inputs are switch-selectable from the front panel. For system applications the position of the switch can be sensed through the interface. An external trigger input is included to control the timing of measurements remotely. And, to control the switching time of an external scanner, scanner-advance output pulses are available at the rear panel. Either GPIB/IEEE-488,* RS-232-C, or an 8-bit/ 16-bit parallel interface option may be used for systems applications. The parallel interfaces will work with DEC computer interfaces DR11C or DRV11.
Folgende Anleitungen sind hier verfügbar:
|Fluke -- 8506A -- Datenblatt|
|Dateigröße:||671.14 Kbytes (687249 Bytes)|
|Qualität:||Gescanntes Dokument, teilweise schwer oder teilweise nicht zu lesen.|
|Upload Datum:||28 Januar 2016|
|Downloads:||89 seit dem 28 Januar 2016|
No comments yet. Be the first!