Geräte Informationen:

California Instruments 4500L-M Netzteil
Hersteller:
California Instruments
Modell: 4500L-M
Datum: 1993
Kategorie: Messgeräte
Gruppe: Netzteil
Beschreibung: Power Source
Informationen:
                                    This instrument is a high efficiency power source that
provides a low distortion sine wave output with either a
single or three-phase conf iguration.
All power systems are constructed from a 4 500L-M power
source. The following table lists the model number of each
power system, the output phase configuration, the number of
4500L,s in the system and the output VA per phase. The table
also shows that increased power is available at a reduced
operating temperature of 35°C.
MODEL
PHASE
#UNITS
VA/PHASE
50°C
35 °C
4500L-3M
3
1
1500
1667
4500L-1M
1
1
4500
5000
9000L-3M
3
2
3000
3333
9000L-1M
1
2
9000
10000
13 500L-3M
3
3
4500
5000
13500L-1M
1
3
13500
15000
27000L-3M
3
6
9000
10000
27000L-1M
1
6
27000
30000
Full power is available from a standard 0 to 135 or 0 to 270
volt range. Optional 67.5/135 volt, 156/312 and 200/400 volt
ranges are also available. Full power is available from 45
to 2.00 KHz for all models except for those with a 200/400
voltage range (EHV) option. The EHV option will operate up
to 1000 Hz. The 4500L-3M has full power available from 45 Hz
to 5.00 KHz. The 4500L-M is illustrated in Figure l-l.
The output frequency can be programmed down to 17 Hz at a
reduced output voltage.

Folgende Anleitungen sind für obiges Gerät verfügbar:

California Instruments -- 4500L-M -- Service- und Bedienungsanleitung
Dateiname: CaliforniaInstruments-7399-Manual-Page-1-Picture
Dokumenttyp: Service- und Bedienungsanleitung
Seitenanzahl: 80
Dateigröße: 2.07 Mbytes (2166905 Bytes)
Sprache: Englisch
Revision:
Dokument-ID/Nummer: 4009-318
Datum: Februar 1993
Qualität: Gescanntes Dokument, teilweise schwer oder teilweise nicht zu lesen.
Upload Datum:
MD5: 3ce6380f322510dd2eca51df55273c4e
ed2kID: d183cbbfdaf2ff9447d8ff8c4d900c8f
Downloads: 17 seit 20 Dezember 2015
Informationen:
1
2
3
4
TITLE
INTRODUCTION .......................... . .
1.1 INTRODUCTION..........................
1.2 GENERAL DESCRIPTION ..................
1.3 ACCESSORY EQUIPMENT/RACK SLIDES . . . .
1.4 SPECIFICATIONS........................
INSTALLATION AND ACCEPTANCE................
2.1 UNPACKING ............................
2.2 POWER REQUIREMENTS....................
2.3 MECHANICAL INSTALLATION ..............
2.4 INPUT WIRING..........................
2.5 OUTPUT CONNECTIONS....................
2.6 EXTERNAL SENSE CONNECTIONS............
2.7 OUTPUT VOLTAGE RANGES ................
2.8 FUNCTION TEST ..... ..............
2.8.1 RANGE SWITCHING .......
2.8.2 LOAD REGULATION TEST........
OPERATION..................................
3.1 GENERAL ..............................
3.2 FRONT PANEL CONTROLS. ... ..........
3.3 FRONT PANEL INDICATORS................
3.4 REAR PANEL CONNECTIONS................
3.4.1 POWER INPUT ................
3.4.2 POWER OUTPUT................
3.4.3 EXTERNAL SENSE..............
3.4.5 SYSTEM INTERFACE............
3.4.6 CLOCK ......................
3.4.7 LOCK........................
3.4.8 DFI ........................
3.4.9 0D AND 0E POWER OUTPUT . . .
CALIBRATION PROCEDURE......................
4.1 GENERAL ..............................
4.2 TEST EQUIPMENT REQUIRED ..............
4.3 OPEN SENSE ADJUSTMENT .........
4.4 GAIN BALANCE ADJUSTMENT ..............
4.5 CURRENT TRANSFORMER ADJUSTMENT. . . . .
4.6 LOAD BALANCE ADJUSTMENT ..............
4.7 CURRENT LIMIT ADJUSTMENT..............
THEORY OF OPERATION........................
5.1 GENERAL..............................
5.2 OVERALL DESCRIPTION ..................
5.3 INPUT POWER SUPPLY....................
5.4 AUXILIARY POWER SUPPLY................
5.5 CURRENT LIMIT BOARD.................. 44
5.6 INDICATOR BOARD. . ................. 44
5.7 RANGE RELAY BOARD.................... 44
5.8 AMPLIFIER MODULES.................... 4 5
5.9 OSCILLATOR MODULE.................... 4 5
5.9.1 CONTROL BOARD.............. 47
5.9.2 WAVEFORM GENERATOR BOARD . . 47
5.10 AX OPTION (Auxiliary Outputs)........ 48
6 MAINTENANCE AND TROUBLESHOOTING .......... 49
6.1 GENERAL............................... 49
6.2 EXCESSIVE OUTPUT VOLTAGE.......... . 49
6.3 POOR OUTPUT VOLTAGE REGULATION .... 49
6.4 OVERTEMPERATURE LAMP ON.............. 50
6.5 OVERLOAD LAMP ON.................... 50
6.6 DISTORTED OUTPUT.................... 51
6.7 NO OUTPUT............................. 51
6.8 MODULE REMOVAL...................... 52
6.9 OSCILLATOR MODULE REMOVAL/REPLACEMENT. 52
6.10 AMPLIFIER REMOVAL/REPLACEMENT........ 52
7 REPLACEABLE PARTS........................ 55
7.1 GENERAL............................... 55
7.2 ORDERING INFORMATION.......... 55
CaliforniaInstruments-7399-Manual-Page-1-Picture
Kostenlos herunterladen


Kommentare

Noch keine Kommentare vorhanden.

Kommentar Hinzufügen

* Pflichtfeld
(wird nicht veröffentlicht)
 
Bold Italic Underline Strike Superscript Subscript Quote Line Bullet Link Email Image Video
 
Smile Sad Huh Laugh Mad Tongue Crying Grin Wink Scared Cool Sleep Blush Unsure Shocked
 
1000
Enter the word shark backwards.
 
Die Antwort lautet:
 
Informiere mich via E-Mail über neue Kommentare.
 
Meine Daten auf diesem Computer.
 
 
Powered by Commentics