Geräte Informationen:

Wavetek 157 Generator
Hersteller:
Wavetek
Modell: 157
Datum:
Kategorie: Messgeräte
Gruppe: Generator
Beschreibung: PROGRAMMABLE WAVEFORM SYNTHESIZER
Informationen:
                                    The Model 157 is a precision source of selectable sine,
square, or triangle waveforms that are generated from 100
μΗz (2% hours per cycle) to 1 MHz in 10 ranges. Output
amplitudes are selectable from 1 millivolt to 10 volts,
peak-to-peak, into a 50-ohm load. This instrument
incorporates a voltage-controlled generator that may be
swept over a 1000:1 frequency ratio with a 0-volt to 5-volt
analog input for frequency modulation of the selected output
frequency.
Four modes of operation can be programmed with the
front-panel controls. Three modes of operation are
programmable from a remote source by static logic levels or
contact closures. Frequency, amplitude, and function also
are programmable from either the front-panel controls or a
remote source.
The instrument is packaged for mounting in a standard
19-inch rack or for operating on a test bench.

Folgende Anleitungen sind hier verfügbar:

Wavetek -- 157 -- Service- und Bedienungsanleitung
Dateiname: Wavetek-6394-Manual-Page-1-Picture
Dokumenttyp: Service- und Bedienungsanleitung
Seitenanzahl: 80
Dateigröße: 8.13 Mbytes (8525652 Bytes)
Sprache: Englisch
Revision:
Dokument-ID/Nummer:
Datum:
Qualität: Elektronisches Dokument, kein Scan, sehr gut lesbar.
Upload Datum:
MD5: d81cceae6291bbd0c1998497491f4019
Downloads: 135 seit dem 17 November 2014
Informationen:
This manual provides instructions for operating, testing,
and maintaining the Wavetek Programmable Waveform
Synthesizer. Sections 1 through 5 include the necessary
information for the basic Model 157. Section 6 consists of
Difference Data that describe specific differences, if any,
from the basic model.


Section 1 GENERAL DESCRIPTION
Scope of
Manual...................................................................................................................................................................1-1
Scope of Equipment
..........................................................................................................................................................1-1
Modes of Operation
..........................................................................................................................................................1-1
Remote Control
Operation................................................................................................................................................1-2
Functional
Descriptions.....................................................................................................................................................1-2
Specifications........................................................................................................................................................................1-3
Section 2 OPERATING INSTRUCTIONS
Installation.............................................................................................................................................................................2-1
Inspection
.............................................................................................................................................................................2-1
Manual Operation
..............................................................................................................................................................2-4
Programming
........................................................................................................................................................................2-5
Section 3 CIRCUIT DESCRIPTION
Introduction
........................................................................................................................................................................3-1
Program Selection
..............................................................................................................................................................3-1
Basic Generator
...................................................................................................................................................................3-3
Low-Frequency
Generator................................................................................................................................................3-6
Sine Conversion
...................................................................................................................................................................3-7
Tone Burst Generation
.....................................................................................................................................................3-7
Power
Supply........................................................................................................................................................................3-9
Section 4 MAINTENANCE
Introduction
........................................................................................................................................................................4-1
Recommended Test
Equipment.......................................................................................................................................4-1
Checkout and Calibration
................................................................................................................................................4-1
Troubleshooting...................................................................................................................................................................4-4
Replacement of Circuit Boards
.......................................................................................................................................4-5
Replacement of Rotary Switches, Dials, or Decimal Lamps
....................................................................................4-6
Section 5 DATA PACKAGE
Introduction
........................................................................................................................................................................5-1
Arrangement
........................................................................................................................................................................5-1
List of
Manufacturers..........................................................................................................................................................5-1
Wavetek-6394-Manual-Page-1-Picture
Kostenlos herunterladen


Comments (0)

No comments yet. Be the first!

Add Comment

* Required information
1000
Enter the last letter of the word satellite.
Powered by Commentics