Geräte Informationen:

Johnson Viking Matchbox Antennenkoppler
Modell: Viking Matchbox
Kategorie: Funk und Kommunikation
Gruppe: Antennenkoppler
                                    The Johnson Matchbox is an antenna coupler designed for
matching antenna and transmission line impedances to a 52
ohm impedance within the amateur bands from 3.5 to 30
megacycles. The Matchbox also provides band switching and
transfer of the coupler from transmitter to receiver and in
addition mutes the receiver and grounds the receiver antenna
terminals during transmission.

The Matchbox is capable of matching the 52 ohm coaxial
output of a transmitter into loads ranging from
approximately 50 ohms to 1200 ohms for balanced lines, and
50 to 2000 ohms for unbalanced lines. Large amounts of
reactance can be compensated for by the coupler, the amount
depending upon the frequency, line or antenna resistance.
The Matchbox, or any coupler, installed at the transmitter
end of the transmission line cannot correct the standing
wave on the transmission line. This standing wave is a
matter of impedance match between the antenna and the
transmission line and may be eliminated in various ways
described in antenna and transmission line literature.

The coupler circuit consists of a parallel resonant network
utilizing an inductor with a coaxial wound coupling link, a
dual tuning capacitor, and a dual differential matching
capacitor as shown in Figure 1. Impedance matching for
either balanced or unbalanced transmission lines and
antennas is accomplished by the front panel controls of the
two dual capacitors without resorting to the customary coil
taps or link adjustments. Adjustment of the Matchbox must be
accomplished by the use of a directional coupler, such as
Johnson no. 250-37,

The Matchbox tuned circuit provides additional harmonic
attenuation of the transmitter output by at least 15 db. The
52 ohm coaxial line between the transmitter and coupler
provides for the insertion of a low pass (TV1) filter such
as the Johnson 250-20 for improved harmonic attenuation. A
terminal is provided on the terminal board for the
installation of an R. F. probe for use with an oscilloscope,
modulation indicator

The Kilowatt Matchboxes (part nos. 250-30 and 250-30-3) have
a switching relay system designed for ,ffast make-slow
break" operation allowing the final amplifier plate voltage
to be cut off before the transmitter load is removed. The
time of delay is fixed between . 15 and .25 of a second
which is ample to allow the relay contacts to break without
any arcing,

Folgende Anleitungen sind für obiges Gerät verfügbar:

Johnson -- Viking Matchbox -- Bedienungsanleitung
Dateiname: Johnson-5496-Manual-Page-1-Picture
Dokumenttyp: Bedienungsanleitung
Seitenanzahl: 11
Dateigröße: 604.67 Kbytes (619177 Bytes)
Sprache: Englisch
Dokument-ID/Nummer: 2-0250-023
Qualität: Gescanntes Dokument, alles ist lesbar.
Upload Datum:
MD5: 6e0506d16f60b0bc8e6d43dddcbc81c4
ed2kID: 9f49ae9433269e6b49db867d3a0434bb
Downloads: 177 seit 01 März 2014
Kostenlos herunterladen


Noch keine Kommentare vorhanden.

Kommentar Hinzufügen

* Pflichtfeld
(wird nicht veröffentlicht)
Bold Italic Underline Strike Superscript Subscript Quote Line Bullet Link Email Image Video
Smile Sad Huh Laugh Mad Tongue Crying Grin Wink Scared Cool Sleep Blush Unsure Shocked
Enter the fifth word of this sentence.
Die Antwort lautet:
Informiere mich via E-Mail über neue Kommentare.
Meine Daten auf diesem Computer.
Powered by Commentics